Pioneer VSX-522-K Owner's Manual - Page 37

7 Additional information About iPod/iPhone "Made for iPod" and "Made for iPhone" mean that an electronic accessory has been designed to connect specifically to iPod or iPhone, respectively, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with iPod or iPhone may affect wireless performance. Apple, iPhone, iPod, iPod shuffle, iPod nano, iPod classic, iPod touch and iTunes are trademarks of Apple Inc., registered in the U.S. and other countries. Resetting the main unit Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this. 1 Switch the receiver into standby. 2 While holding down BAND, press and hold STANDBY/ON for about two seconds. 3 When you see RESET? appear in the display, press AUTO SURROUND/STREAM DIRECT. OK? shows in the display. 4 Press ALC/STANDARD SURR to confirm. OK appears in the display to indicate that the receiver has been reset to the factory default settings. Important • If the ARC function is ON, you may not be able to initialize the unit. If this happens, turn OFF the ARC function or turn OFF all the connected device before turning OFF (STANDBY) the power for this unit, and initialize after the HDMI indicator goes out. Cleaning the unit • Use a polishing cloth or dry cloth to wipe off dust and dirt. • When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers. • Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surface. Specifications Amplifier section Continuous average power output of 80 watts* per channel, min., at 8 ohms, from 20 Hz to 20 000 Hz with no more than 0.08 %** total harmonic distortion. Front (stereo 80 W + 80 W Power output (1 kHz, 6 Ω, 1 140 W per channel Guaranteed speaker impedance 6 Ω to 16 Ω * Measured pursuant to the Federal Trade Commission's Trade Regulation rule on Power Output Claims for Amplifiers ** Measured by Audio Spectrum Analyzer Audio Section Input (Sensitivity/Impedance) LINE 200 mV/47 kΩ Signal-to-Noise Ratio (IHF, short circuited, A network) LINE 98 dB Signal-to-Noise Ratio [EIA, at 1 W (1 kHz)] LINE 79 dB Video Section Signal level Composite 1 Vp-p (75 Ω) Tuner Section Frequency Range (FM 87.5 MHz to 108 MHz Antenna Input (FM 75 Ω unbalanced Frequency Range (AM 530 kHz to 1700 kHz Antenna (AM Loop antenna Digital In/Out Section HDMI terminal Type A (19-pin) HDMI output type 5 V, 100 mA USB (iPod) terminal USB2.0 Full Speed (Type A) Miscellaneous Power Requirements AC 120 V, 60 Hz Power Consumption 415 W In standby 0.4 W (ARC OFF) Dimensions . . . . . .435 mm (W) x 168 mm (H) x 342.5 mm (D) 173/16 in. (W) x 65/8 in. (H) x 131/2 in. (D) Weight (without package 8.7 kg (19 lb 3 oz) Furnished Parts Microphone (for Auto MCACC setup 1 Remote control 1 Dry cell batteries (AAA size IEC R03 2 AM loop antenna 1 FM wire antenna 1 Warranty card 1 Quick start guide 1 Safety Brochure 1 These operating instructions (CD-ROM) Note • Specifications and the design are subject to possible modifications without notice, due to improvements. 37