Pioneer VSX-522-K Owner's Manual - Page 9

1 Controls and displays 11 Component control buttons The main buttons (, , etc.) are used to control a component after you have selected it using the input function buttons. The controls above these buttons can be accessed after you have selected the corresponding input function button (BD, DVD and CD). These buttons also function as described below. Press RECEIVER first to access: BASS +/-, TRE +/- - Use to adjust Bass or Treble. • These controls are disabled when the listening mode is set to DIRECT or PURE DIRECT. • When the front speaker is set at SMALL in the Speaker Setting (or automatically via the Auto MCACC setup) and the X.Over is set above 150 Hz, the subwoofer channel level will be adjusted by pressing BASS +/- (page 31). 12 Number buttons and other component controls Use the number buttons to directly select a radio frequency (page 24) or the tracks on a CD, etc. There are other buttons that can be accessed after RECEIVER is pressed. (For example MIDNIGHT, etc.) SB CH - Press to select ON, AUTO or OFF the surround back channel (page 27). CH SELECT - Press repeatedly to select a channel, then use LEV +/- to adjust the level (page 31). LEV +/- - Use to adjust the channel level. MIDNIGHT - Switches to Midnight or Loudness listening (page 28). SPEAKERS - Use to change the speaker system on or off. When the SP OFF is selected, no sound is output from the speakers connected to this receiver. DIMMER - Dims or brightens the display. The brightness can be controlled in four steps. 13 SOURCE Turns on or off the power of the Pioneer DVD/DVR units when BD, DVD, DVR/BDR or CD is selected using the input function buttons. 14 TV CONTROL buttons These buttons can control only be used with Pioneer TVs.  - Use to turn on/off the power of the TV. INPUT - Use to select the TV input signal. CH +/- - Use to select channels. VOL +/- - Use to adjust the volume on your TV. 15 VOLUME +/- Use to set the listening volume. 16 MUTE Mutes/unmutes the sound. 17 DISP Switches the display of this unit. The listening mode, sound volume, Pre Out setting or input name can be checked by selecting an input source. • The Pre Out setting may or may not be displayed, depending on the input source you have selected. Loading the batteries The batteries included with the unit are to check initial operations; they may not last over a long period. We recommend using alkaline batteries that have a longer life. CAUTION • Incorrect use of batteries may result in such hazards as leakage and bursting. Observe the following precautions: - Never use new and old batteries together. - Insert the plus and minus sides of the batteries properly according to the marks in the battery case. - Batteries with the same shape may have different voltages. Do not use different batteries together. - When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules that apply in your country or area. - Do not use or store batteries in direct sunlight or other excessively hot place, such as inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It can also reduce the life or performance of batteries. Operating range of remote control The remote control may not work properly if: • There are obstacles between the remote control and the receiver's remote sensor. • Direct sunlight or fluorescent light is shining onto the remote sensor. • The receiver is located near a device that is emitting infrared rays. • The receiver is operated simultaneously with another infrared remote control unit. 30° 30° 7 m (23 ft.) 9