Home » Pioneer Manuals » Audio Components » Pioneer VSX-820-K » Manual Viewer

Pioneer VSX-820-K Owner's Manual - Page 21

About HDMI, Analog audio cables, Digital audio cables, Video cables, Standard RCA video cables - 3d

UPC - 884938109277

Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

Connecting your equipment 03 English Deutsch Français Italiano Nederlands Español About HDMI The HDMI connection transfers uncompressed digital video, as well as almost every kind of digital audio that the connected component is compatible with, including DVDVideo, DVD-Audio, SACD, Dolby Digital Plus, Dolby TrueHD, DTS-HD Master Audio (see below for limitations), Video CD/Super VCD and CD. This receiver incorporates High-Definition Multimedia Interface (HDMI™) technology. This receiver supports the functions described below through HDMI connections.1 • Digital transfer of uncompressed video (contents protected by HDCP (1080p/24, 1080p/60, etc.)) • 3D signal transfer2 • Deep Color signal transfer2 • x.v.Color signal transfer2 • Input of multi-channel linear PCM digital audio signals (192 kHz or less) for up to 8 channels • Input of the following digital audio formats:3 - Dolby Digital, Dolby Digital Plus, DTS, High bitrate audio (Dolby TrueHD, DTS-HD Master Audio), DVD-Audio, CD, SACD (DSD signal), Video CD, Super VCD HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing, LLC. "x.v.Color" and x.v.Color logo are trademarks of Sony Corporation. Analog audio cables Use stereo RCA phono cables to connect analog audio components. These cables are typically red and white, and you should connect the red plugs to R (right) terminals and white plugs to L (left) terminals. Analog audio cables Right (red) Left (white) Digital audio cables Commercially available coaxial digital audio cables or optical cables should be used to connect digital components to this receiver.4 Coaxial digital audio cable Optical cable Video cables Standard RCA video cables These cables are the most common type of video connection and are used to connect to the composite video terminals. The yellow plugs distinguish them from cables for audio. Standard RCA video cable Note 1 • Use a High Speed HDMI™ cable. If HDMI cable other than a High Speed HDMI™ cable is used, it may not work properly. • When an HDMI cable with a built-in equalizer is connected, it may not operate properly. 2 Signal transfer is only possible when connected to a compatible component. 3 • HDMI format digital audio transmissions require a longer time to be recognized. Due to this, interruption in the audio may occur when switching between audio formats or beginning playback. • Turning on/off the device connected to this unit's HDMI OUT terminal during playback, or disconnecting/connecting the HDMI cable during playback, may cause noise or interrupted audio. 4 • When connecting optical cables, be careful when inserting the plug not to damage the shutter protecting the optical socket. • When storing optical cable, coil loosely. The cable may be damaged if bent around sharp corners. • You can also use a standard RCA video cable for coaxial digital connections. 21 En

Section	Page
Contents	4
Before you start	7
Checking what’s in the box	7
Loading the batteries	7
Installing the receiver	7
Ventilation	8
Controls and displays	9
Front panel	9
Operating range of remote control	10
Display	11
Remote control	13
Connecting your equipment	16
Placing the speakers	16
Hints on the speaker placement	17
Connecting the speakers	18
Connect the surround back or front height speakers	19
Switching the speaker system	20
Making cable connections	20
HDMI cables	20
About HDMI	21
Analog audio cables	21
Digital audio cables	21
Video cables	21
About video outputs connection	22
Connecting a TV and playback components	23
Connecting using HDMI	23
Connecting your component with no HDMI terminal	24
Connecting a satellite receiver or other digital set-top box	25
Connecting an HDD/DVD recorder, VCR and other video sources	25
Using the component video jacks	26
Connecting other audio components	26
Connecting antennas	27
Using external antennas	27
Connecting to the front panel video terminal	28
Plugging in the receiver	28
Basic Setup	29
Automatically setting up for surround sound (MCACC)	29
Other problems when using the Auto MCACC Setup	31
Listening to your system	32
Basic playback	32
Auto playback	33
Listening in surround sound	33
Using the Advanced surround effects	34
Listening in stereo	35
Using Front Stage Surround Advance	35
Using Stream Direct	36
Using the Sound Retriever	36
Better sound using Phase Control	36
Listening with Acoustic Calibration EQ	37
Using surround back channel processing	37
Setting the Up Mix function	38
Setting the Audio options	38
Choosing the input signal	41
Using the headphone	41
The System Setup menu	42
Using the System Setup menu	42
Manual speaker setup	43
Speaker Setting	43
Crossover Network	45
Channel Level	45
Speaker Distance	46
The Input Assign menu	46
The Pre Out Setting	47
Using the tuner	48
Listening to the radio	48
Improving FM stereo sound	48
Saving station presets	48
Listening to station presets	49
Naming preset stations	49
Making recordings	50
Making an audio or a video recording	50
Controlling the rest of your system	51
Setting the remote to control other components	51
Selecting preset codes directly	51
Clearing all the remote control settings	52
Controls for TVs	53
Controls for other components	54
Preset Code List	55
Other connections	58
Connecting an iPod	58
Connecting your iPod to the receiver	58
iPod playback	59
Watching photos and video content	60
About iPod	60
Connecting a USB device	61
Connecting your USB device to the receiver	61
Basic playback controls	61
Compressed audio compatibility	62
Bluetooth® ADAPTER for Wireless Enjoyment of Music	63
Wireless music play	63
Connecting Optional Bluetooth ADAPTER	63
Pairing Bluetooth ADAPTER and Bluetooth wireless technology device	64
Listening to Music Contents of Bluetooth wireless technology device with Your System	64
Listening to Satellite Radio	65
Connecting your SiriusConnectTM Tuner	66
Listening to SIRIUS Radio	66
Saving channel presets	67
Using the SIRIUS Menu	67
Additional information	68
Troubleshooting	68
HDMI	71
Important information regarding the HDMI connection	72
iPod messages	72
USB messages	73
SIRIUS radio messages	73
Resetting the main unit	74
Specifications	74
Cleaning the unit	75
091221_VSX-820_Fr.book.pdf	90
Installation des enceintes	90
Conseils d’installation des enceintes	91
Raccordement des enceintes	92
Connectez les enceintes surround arrière ou surround avant-haut	93
Permutation du système d’enceintes	94
Raccordements des câbles	94
Câbles HDMI	94
À propos de HDMI	95
Câbles audio analogiques	95
Câbles audio numériques	95
Câbles vidéo	95
À propos du raccordement des sorties vidéo	96
Raccordement d’un téléviseur et de périphériques de lecture	97
Connexion au moyen de l’interface HDMI	97
Raccordement d’un équipement dépourvu de borne HDMI	98
Raccordement d’un récepteur satellite ou d’un boîtier décodeur numérique	99
Raccordement d’un enregistreur HDD/DVD, magnétoscope et autres sources vidéo	99
Utilisation des prises femelles vidéo en composantes	100
Raccordement d’autres appareils audio	100
Raccordement des antennes	101
Utilisation des antennes externes	101
Raccordement à la borne vidéo du panneau frontal	102
Branchement du récepteur	102
Configuration de base	103
Configuration automatique du son surround (MCACC)	103
Autres problèmes lors de l’utilisation de la configuration MCACC automatique	105
Écoute de sources à l’aide de votre système	106
Lecture de base	106
Lecture en mode Auto	107
Écoute d’une source en son surround	107
Utilisation des effets surround avancés	108
Écoute en mode stéréo	109
Utilisation de la fonction Front Stage Surround Advance	109
Utilisation des modes Stream Direct	110
Utilisation de la fonction Sound Retriever	110
Un son meilleur grâce à la fonction Phase Control	110
Écoute avec la fonction Acoustic Calibration EQ	111
Utilisation du traitement de canal surround arrière	111
Réglage de la fonction Up Mix	112
Réglage des options audio	112
Choix du signal d’entrée	115
Utilisation du casque d’écoute	115
Menu de configuration du système	116
Utilisation du menu de configuration du système	116
Réglage manuel des enceintes	117
Réglage des enceintes	117
Réseau de recouvrement	119
Niveau des canaux	119
Distance des enceintes	120
Menu d’affectation d’entrée	120
Configuration de l’option Pre Out	121
Utilisation du tuner	122
Pour écouter la radio	122
Amélioration du son stéréo FM	122
Mémorisation de stations préréglées	122
Pour écouter les stations préréglées	123
Attribution de noms aux stations préréglées	123
Pour faire un enregistrement	124
Faire un enregistrement audio ou vidéo	124
Commander le reste de votre système	125
Configurer la télécommande pour commander d’autres composants	125
Sélectionner directement des codes de préréglage	125
Suppression de tous les réglages de la télécommande	126
Commandes pour les téléviseurs	126
Commandes pour autres composants	127
Liste des codes de préréglage	129
Autres raccordements	132
Connexion d’un iPod	132
Raccordement de votre iPod au récepteur	132
Lecture de l’iPod	133
Visualisation de photos et de contenu vidéo	134
À propos d’iPod	134
Raccordement d’un appareil USB	135
Raccordement de votre périphérique USB au récepteur	135
Commandes de lecture de base	135
Compatibilité des fichiers audio compressés	136
ADAPTATEUR Bluetooth® pour profiter de la musique sans fil	137
Lecture de musique sans fil	137
Raccordement de l’ADAPTATEUR Bluetooth optionnel	137
Appairage de l’ADAPTATEUR Bluetooth et du périphérique à technologie sans fil Bluetooth	138
Ecoute de contenus musicaux d’un périphérique à technologie sans fil Bluetooth avec votre système	138
Écoute de la radio satellite	139
Raccordement de votre syntoniseur SiriusConnectTM	140
Écoute de SIRIUS Radio	140
Mémorisation des stations présélectionnées	141
Utilisation du Menu SIRIUS	141
Informations complémentaires	142
Guide de dépannage	142
HDMI	145
Information importante concernant la connexion HDMI	146
iPod messages	146
Messages USB	146
Messages radio SIRIUS	147
Réinitialisation de l’appareil principal	148
Spécifications	148

Match case Limit results 1 per page

Connecting your equipment

English

Français

Deutsch

Nederlands

Italiano

Español

About HDMI

The HDMI connection transfers

uncompressed digital video, as well as almost

every kind of digital audio that the connected

component is compatible with, including DVD-

Video, DVD-Audio, SACD, Dolby Digital Plus,

Dolby TrueHD, DTS-HD Master Audio (see

below for limitations), Video CD/Super VCD

and CD.

This receiver incorporates High-Definition

Multimedia Interface (HDMI™) technology.

This receiver supports the functions described

below through HDMI connections.

•

Digital transfer of uncompressed video

(contents protected by HDCP (1080p/24,

1080p/60, etc.))

•

3D signal transfer

•

Deep Color signal transfer

•

x.v.Color signal transfer

•

Input of multi-channel linear PCM digital

audio signals (192 kHz or less) for up to 8

channels

•

Input of the following digital audio formats:

– Dolby Digital, Dolby Digital Plus, DTS,

High bitrate audio (Dolby TrueHD, DTS-HD

Master Audio), DVD-Audio, CD, SACD

(DSD signal), Video CD, Super VCD

HDMI, the HDMI logo and High-Definition

Multimedia Interface are trademarks or

registered trademarks of HDMI Licensing, LLC.

“x.v.Color” and x.v.Color logo are trademarks of

Sony Cor

oration.

Analog audio cables

Use stereo RCA phono cables to connect

analog audio components. These cables are

typically red and white, and you should

connect the red plugs to R (right) terminals

and white plugs to L (left) terminals.

Digital audio cables

Commercially available coaxial digital audio

cables or optical cables should be used to

connect digital components to this receiver.

Video cables

Standard RCA video cables

These cables are the most common type of

video connection and are used to connect to

the composite video terminals. The yellow

plugs distinguish them from cables for audio.

Note

• Use a High Speed HDMI™ cable. If HDMI cable other than a High Speed HDMI™ cable is used, it may not work properly.

• When an HDMI cable with a built-in equalizer is connected, it may not operate properly.

Signal transfer is only possible when connected to a compatible component.

• HDMI format digital audio transmissions require a longer time to be recognized. Due to this, interruption in the audio may

occur when switching between audio formats or beginning playback.

• Turning on/off the device connected to this unit's HDMI OUT terminal during playback, or disconnecting/connecting the

HDMI cable during playback, may cause noise or interrupted audio.

• When connecting optical cables, be careful when inserting the plug not to damage the shutter protecting the optical socket.

• When storing optical cable, coil loosely. The cable may be damaged if bent around sharp corners.

• You can also use a standard RCA video cable for coaxial digital connections.

Right (red)

Analog audio cables

Left (white)

Coaxial digital audio cable

tical cable

Standard RCA video cable