Pioneer VSX-820-K Owner's Manual - Page 70
LARGE, SMALL, DIMMER, ADAPTER PORT, technology device and the unit. Set - remote control replacement
UPC - 884938109277
View all Pioneer VSX-820-K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
11 Additional information Problem Remedy There seems to be a time lag between the speakers and the output of the subwoofer. • See Automatically setting up for surround sound (MCACC) on page 29 to set up your system again using MCACC (this will automatically compensate for a delay in the subwoofer output). After using the Auto • Low-frequency noise could have been caused by an air conditioner or MCACC Setup, the speaker motor. Switch off all appliances in the room and rerun the Auto MCACC size setting (LARGE or Setup. SMALL) is incorrect. Can't operate the remote control. • Replace the batteries (refer to page 7). • Operate within 7 m (23 ft.), 30° of the remote sensor (refer to page 10). • Remove the obstacle or operate from another position. • Avoid exposing the remote sensor on the front panel to direct light. The display is dark or off. • Press DIMMER on the control repeatedly to return to the default. The Bluetooth wireless • Check that no object that emits electromagnetic waves in the 2.4 GHz technology device cannot band (microwave oven, wireless LAN device or Bluetooth wireless be connected or operated. technology apparatus) is near the unit. If such an object is near the unit, Sound from the Bluetooth set the unit far from it. Or, stop using the object emitting the wireless technology device electromagnetic waves. is not emitted or the sound • Check that the Bluetooth wireless technology device is not too far from is interrupted. the unit and that obstructions are not set between the Bluetooth wireless technology device and the unit. Set the Bluetooth wireless technology device and the unit so that the distance between them is less than about 10 m (32 ft.) and no obstructions exist between them. • Check that the Bluetooth ADAPTER and the ADAPTER PORT of the unit are correctly connected. • The Bluetooth wireless technology device may not be set to the communication mode supporting the Bluetooth wireless technology. Check the setting of the Bluetooth wireless technology device. • Check that pairing is correct. The pairing setting was deleted from this unit or the Bluetooth wireless technology device. Reset the pairing. • Check that the profile is correct. Use a Bluetooth wireless technology device that supports A2DP profile and AVRCP profile. 70 En