Pioneer VSX-D509S Owner's Manual - Page 23

Preparations Set up Setting Up the Remote Control In addition to controlling the receiver, the supplied remote control can operate your other components (DVD, MD, VCR, TV, LD, CD, etc.). If your component(s) are listed in the "Preset Code List", simply recall the corresponding preset code. Recalling preset codes (VSX-D509S) The following steps show you how to recall preset codes for each MULTI CONTROL button. Once the preset code is assigned, pressing the button will automatically set the remote to operate the respective component. memo • Refer to "Preset Code List" on pages 53 to 56 for the components and manufacturers available. • Refer to "Controlling the Rest of Your System" on pages 46 to 50 for detailed explanations on how to operate your other components. SOURCE RECEIVER DVD RCV TV VCR MULTI CONTROL CD TUN CD-R TVC 1 2 3 MIDNIGHT 5.1CH ATT 4 5 6 SIGNAL SELECT 7 EFFECT 8 9 +10 DISC 0 ENTER TV CONTROL TV TV VOL TVFUNC MASTERVOLUME MENU CHANNEL FQ ST ST ENTER FQ 8 D.ACCESS 3 BAND 1 CLASS ¡ MPX DTV ON / OFF DTV MENU 7 4 ¢ 2 DSP TEST TONE CH SELECT CH LEVEL FL DIMMER LOUDNESS FUNCTION MUTING SETUP Î AV PRE-PROGRAMMED AND LEARNING REMOTE CONTROL UNIT LED 2 3 1,4 1 Press SETUP and hold for three seconds to select the preset mode. The LED will blink twice. ( ) To cancel the preset mode Press SETUP. 2 Press the MULTI CONTROL button for the component you want to control. Each button can be set to control one of the following components DVD : DVD/LD player or DVD Recorder TV : TV , Satellite tuner or Cable TV tuner CD : CD player, CD-R, Tape deck or MD recorder CD-R : CD player, CD-R, Tape deck or MD recorder VCR : VCR or Digital Video Recorder TVC : TV , Satellite tuner or Cable TV tuner TUN : FM/ AM tuner 3 Use the number buttons to enter the 4 digit setup code. The LED will blink after each digit is input and will blink twice to confirm a valid code has been input. If the LED shows one long blink it means an invalid code has been input. Check the preset code list and try again. If you are not able to input a preset code you can refer to page 26 to teach the remote control individual commands. Repeat steps 1 through 3 to assign preset codes for as many components as necessary. 4 Press SETUP to exit the preset mode. The remote control returns to the previous operation mode. It will also return to the previous mode after ten seconds of inactivify. memo • The RCV (Receiver) button cannot be preset. • You can only input a code for the component type written on each MULTI CONTROL button. See page 29 for information on how to program a different type of component than specified on the button. • If you recall a preset code for the tuner (TUN MULTI COTROL), you will not be able to control the built-in tuner 23 of this receiver using the remote. To reset the remote to the built-in tuner, input the preset code 0080.