Pioneer VSX-D509S Owner's Manual - Page 52
Symptom, Cause, Remedy, If the unit does not operate normally due to external effects such as static
View all Pioneer VSX-D509S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Additional Information Symptom Broadcast stations cannot be selected automatically. No sound from surround or center speakers. Cause • Weak radio signal. • Speaker settings are incorrect. • The rear and/or center levels are turned down. Sound is produced from other components, but not from LD or DVD player. No sound is output or a noise is output when software with DTS is played back. When a search is performed by a DTS compatible CD player during playback, noise is output. Cannot be remote controlled. • The surround and/or center speakers are disconnected. • SIGNAL SELECT is set incorrectly. • The digital inputs are assigned incorrectly, or not at all. • SIGNAL SELECT is set to "ANALOG". • A DVD player not compatible with DTS is used, or the setting of DVD player is incorrect. • The digital output level is adjusted on a CD player or other component equipped with digital output level adjustment capability. (The DTS signal has been altered by the player, and cannot be read.) • The search function performed by the player slightly alters the digital information, making it unreadable. • The remote control batteries have worn out. • Too far away or bad angle of operation. The display is dark or off. • There is an obstacle between the receiver and the remote control. • Strong light such as fluorescent light is shining onto the unit's remote control signal light-receiving window. • The FL DIMMER button is pushed. Remedy • Connect an outdoor antenna (refer to page 13). • Refer to "SPEAKERS setting mode" on page 17 to check the speaker settings. • Refer to "Setting the volume level of each channel" on page 22 to check the speaker levels. • Connect the speakers (refer to page 14). • Set SIGNAL SELECT to "DIGITAL" or "ANALOG" according to the type of connections made. (refer to page 37). • Set the digital input settings correctly (refer to pages 20-21). • Make digital connections (refer to page 11) and set SIGNAL SELECT to "DIGITAL" (refer to page 37). • Refer to the instruction manual supplied with the DVD player. • Set the digital volume level of the player to full, or to the neutral position. • This is not a malfunction, but be sure to turn the volume down to prevent the output of loud noise from your speakers. • Replace the batteries (refer to page 7). • Operate within 23 feet ( 7 m), 30° of the remote sensor on the front panel (refer to page 7). • Remove the obstacle or operate from another position. • Avoid exposing the remote sensor on the front panel to direct light. • Press FL DIMMER on the remote control repeatedly to return to the default. If the unit does not operate normally due to external effects such as static electricity Disconnect the power plug from the outlet and insert again to return to normal operating conditions. 52