Home » Poulan Manuals » Lawn & Garden » Poulan 2050 » Manual Viewer

Poulan 2050 User Manual

Poulan 2050 Manual

Get Poulan 2050 PDF manuals and user guides

View all Poulan 2050 manuals

Add to My Manuals
Save this manual to your list of manuals

Poulan 2050 manual content summary:

Poulan 2050 | User Manual - Page 1
ENGLISH R 2050 2150 ESPAÑOL UR L For Occasional Use Only WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. ADVERTENCIA: Lea el manual del operador y siga todas las advertencias e instrucciones de
Poulan 2050 | User Manual - Page 2
for the bar and chain combination on the label. SAFETY RULES WARNING: Always disconnect spark plug wire and place wire where it cannot contact spark plug to prevent accidental starting when setting up, transporting, adjusting or making repairs except carburetor adjustments. Because a chain saw is
Poulan 2050 | User Manual - Page 3
oil caps, screws, and fasteners securely tightened. S Use only POULAN or POULAN PRO accessories and replacement parts as recommended. HANDLE FUEL WITH CAUTION S Do not smoke while handling fuel or while operating the saw. S Eliminate all sources of sparks or flame in the areas where fuel is mixed or
Poulan 2050 | User Manual - Page 4
chain saw user, do not rely only on safety devices. You must follow all safety precautions, instructions, and maintenance in this manual to help avoid kickback and other forces which can result in serious injury. S Reduced--Kickback Guide Bar, designed with a small radius tip which reduces the size
Poulan 2050 | User Manual - Page 5
TO AVOID KICKBACK. Reduced--kickback guide bars and low--kickback saw chains reduce the chance and magnitude of kickback and are recommended. Your saw has a low kickback chain and bar as original equipment. Repairs on a chain brake should be made by an authorized servicing dealer. Take your unit to
Poulan 2050 | User Manual - Page 6
the teeth in the sprocket. S Start at the top of the bar and fit chain into groove around the guide bar. S Pull the bar forward until the chain is snug in the groove of the bar. S Hold guide bar against the saw frame and install the chain brake. Make sure the adjusting pin is aligned with the hole
Poulan 2050 | User Manual - Page 7
below the bar. S Lift up the tip of the bar and tighten the chain brake nuts with the assembly tool. S Recheck chain tension. Chain Brake Nuts WARNING: If the saw is operated with a loose chain, the chain could jump off the guide bar and result in serious injury. Chain Adjustment Chain Brake Nuts
Poulan 2050 | User Manual - Page 8
various controls and adjustments. Save this manual for future reference. Chain Front Hand Guard Adjustment Tool (Bar Tool) Chain Muffler Front Handle Starter Rope ON/STOP Switch Primer Bulb Starter Bar Oil Fill Cap Housing Fuel Mix Fill Cap Cylinder Cover Fast Idle Throttle Lock Lockout
Poulan 2050 | User Manual - Page 9
until the fuel lines and carburetor are empty. Use fresh fuel next season. See STORAGE section for additional information. STARTING WARNING: he chain must not move when the engine runs at idle speed. If the chain moves at idle speed refer to CARBURETOR ADJUSTMENT within this manual. Avoid contact
Poulan 2050 | User Manual - Page 10
will not stop the chain. The chain brake should be replaced by an authorized service dealer if any part is worn to less than 1/32" thick. Repairs on a chain brake should be made by an authorized service dealer. Take your unit to the place of pur- S This saw is equipped with a chain brake. The brake
Poulan 2050 | User Manual - Page 11
idle. If you run the saw at full throttle without a cutting load, unnecessary wear can occur to the chain, bar, and engine. S To avoid losing control when cut is complete, do not put pressure on saw at end of cut. S Stop the engine before setting the saw rear and diagonal to the line of fall. Plan a
Poulan 2050 | User Manual - Page 12
and chain damage. starts to fall, stop saw, put it down, and get away quickly on your planned retreat path. S DO NOT cut down a partially fallen tree with your saw. Be extremely cautious with partially fallen trees that may be poorly supported. When a tree doesn't fall completely, set the saw
Poulan 2050 | User Manual - Page 13
each use For loose parts Before each use Inspect and Clean: Bar Before each use Complete saw After each use Air filter Every 5 hours* Chain brake Every 5 hours* Spark arresting screen and muffler Every 25 hours* Replace spark plug . Yearly Replace fuel filter . . . Yearly * Hours of Operation
Poulan 2050 | User Manual - Page 14
. Air Filter Cylinder Cover Screws Cylinder Cover S Reinstall muffler cover and 2 screws (7-8 ft/lbs). CARBURETOR ADJUSTMENTS Your carburetor is equipped with limiter caps. Carburetor adjustment is a complicated task. We recommend that you take your unit to an Authorized Service Dealer. BAR
Poulan 2050 | User Manual - Page 15
fuel line; repair or replace. Engine will not idle properly. S Carburetor requires . adjustment S Crankshaft seals worn. S Contact an Authorized Service Dealer. S Contact an Authorized Service Dealer. Engine will not accelerate, lacks power, or dies under a load. S Air filter dirty. S Spark
Poulan 2050 | User Manual - Page 16
--up, spark plugs, filters, starter ropes, starter springs, chain sharpening, bars, chains, and other parts which wear and require replacement with reasonable use during the warranty period. This warranty does not cover predelivery set--up, installation of guide bar and chain, and normal adjustments
Poulan 2050 | User Manual - Page 17
POULAN/WEED EATER approved replacement part used in the performance of any warranty mainte- nance or repair on emission related parts will be provided without charge to the owner if the part is under warranty. EMISSION CON- TROL WARRANTY PARTS LIST: Carbure- tor, Ignition System: Spark Plug