Poulan HDR500E User Manual
Poulan HDR500E Manual
 |
View all Poulan HDR500E manuals
Add to My Manuals
Save this manual to your list of manuals |
Poulan HDR500E manual content summary:
- Poulan HDR500E | User Manual - Page 1
coo itali4i1Lra,006 OWNER'S MANUAL MODEL NO. HDR500E 5 HP 17 Inch Tiller Assembly • Operation • Customer Responsibilities • Service and Adjustments • Storage • Troubleshooting • Repair Parts For Parts and Service, contact our authorized distributor: call 1-800-849-1297 For Technical Assistance: call - Poulan HDR500E | User Manual - Page 2
Operation Practices for Walk-Behind Powered Rotary Tillers TRAINING Read the Owner's Manual carefully. Be thoroughly familiar with the in any enclosure. • Always refer to the operator's guide instructions for important details if the tiller is to be stored for an extended period. - IMPORTANT - Poulan HDR500E | User Manual - Page 3
technicians and the proper tools to service or repair this unit. Please read and retain this manual. The instructions will enable you to assemble and maintain your tiller properly. Always observe the "SAFETY RULES". MODEL NUMBER HDR500E PRODUCT SPECIFICATIONS HORSEPOWER: 5.0 HP DISPLACEMENT: 12 - Poulan HDR500E | User Manual - Page 4
C.F CONTENTS SAFETY RULES CUSTOMER RESPONSIBILITIES PRODUCT SPECIFICATIONS WARRANTY ASSEMBLY OPERATION 2 3,13-15 3 3 5-7 8-12 MAINTENANCE SCHEDULE SERVICE & ADJUSTMENTS STORAGE TROUBLESHOOTING REPAIR PARTS-TILLER 13 15-18 19 20 21-27 INDEX A Adjustments: Depth Stake Handle Height Side Shields - Poulan HDR500E | User Manual - Page 5
FRONT LEFT RIGHT OPERATOR'S POSITION (See Fig. 1) When right or left hand is mentioned in this manual, it means when you are in the operating position (standing behind tiller handles). OPERATOR'S POSITION FIG. 1 CONTENTS OF HARDWARE PACK (2) Handle Locks 11111111111 (1) Carriage Bolt 3/8-16 UNC - Poulan HDR500E | User Manual - Page 6
CAREFUL NOT TO STRETCH OR KINK CABLES. • While holding handle assembly, cut cable ties securing handle assembly to top frame. Let handle assembly rest on tiller. • Remove top frame of carton. • Slowly ease handle assembly up and place on top of carton. • Cut down right hand front and right hand rear - Poulan HDR500E | User Manual - Page 7
position (See Fig. 6) • Tilt tiller forward by lifting handle. Separate cardboard cover from leveling shield. • Rotate tiller handle to the right and pull tiller out of carton. CONTROL BAR CLUTCH operator. (See "TO ADJUST HANDLE HEIGHT" in the Service and Adjustments section of this manual). 7 - Poulan HDR500E | User Manual - Page 8
to familiarize yourself with the I6Cation of various controls and adjustments. Save this manual for future reference. These symbols may appear on your Tiller or in literature supplied with the product. Learn and understand their meaning. F FNR TILLING FORWARD NEUTRAL REVERSE CAUTION ENGINE OR - Poulan HDR500E | User Manual - Page 9
mask over the spectacles or standard safety glasses. HOW TO USE YOUR TILLER Know how to operate all controls before adding fuel and oil or more versatile tilling and cultivating, or to more easily transport your tiller. SHALLOWEST TILLING DEEPEST TILLING DEPTH STAKE 0 0 0 0 TRANSPORT POSITION - Poulan HDR500E | User Manual - Page 10
" on page 3 of this manual. All oil must meet A.P.I. Service Classification SF, SG or SH. the drive control bar against the handle to start tiller movement. Tines will not turn. • Move throttle an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage - Poulan HDR500E | User Manual - Page 11
performance. See "TO ADJUST CARBURETOR" in the Service and Adjustments section of this manual. NOTE: If engine does not start, see troubleshooting points. SPARK PLUG CHOKE e CONTROL TILLING HINTS CAUTION: Until youareaccustomed to handling your tiller, start actual field use with throttle in - Poulan HDR500E | User Manual - Page 12
. 16 INNER VIEW OF TIRE HAIRPIN CLIP FIG. 15 ADJUST WHEELS FOR CULTIVATING (See Figs. 16 and 17) • Place blocks under right hand side of tiller and remove hairpin clip and clevis pin from right hand wheel. • Move wheel outward approximately 1 inch (2.5 cm) until hole in inner wheel hub lines up - Poulan HDR500E | User Manual - Page 13
full value from the warranty, the operator must maintain tiller as instructed in this manual. Some adjustments will need to be made periodically to properly maintain your tiller. All adjustments in the Service and Adjustments section of this manual should be checked at least once each season. • Once - Poulan HDR500E | User Manual - Page 14
a funnel to prevent oil spill on tiller, and catch oil in a suitable container. • Remove drain plug. • Tip tiller forward to drain oil. • After ENGINE OIL LEVEL" in the Operation section of this manual. AIR CLEANER (See Fig. 20) Service aircleaner cartridge every twenty-five hours, more often if - Poulan HDR500E | User Manual - Page 15
on page 3 of this manual. TRANSMISSION Your transmission is sealed and will only req4Ve lubrication if serviced. CLEANING Clean engine, wheels TO REMOVE WHEEL (See Fig. 23) • Place blocks under transmission to keep tiller from tipping. • Remove hairpin clip and clevis pin from wheel. • Remove wheel - Poulan HDR500E | User Manual - Page 16
SERVICE AND ADJUSTMENTS TINE REPLACEMENT (See Figs. 24, 25 and 26) a CAUTION: ' Tines are sharp. Wear gloves or other protection when handling tines. A badly worn tine causes your tiller to work harder and dig more shallow. Most important, worn tines cannot chop and shred organic matter as - Poulan HDR500E | User Manual - Page 17
SERVICE AND ADJUSTMENTS TO REMOVE BELT GUARD (See Fig. 27) NOTE: For ease of removal, remove hairpin clip and clevis pin from left wheel. Pull wheel out from tiller belt guard as described in "TO REMOVE BELT GUARD". • Loosen belt guides "A" and "B" and also nuts "C" and • Remove old belt by slipping - Poulan HDR500E | User Manual - Page 18
THE FACTORY HIGH SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACT YOUR NEAREST AUTHORIZED SERVICE CENTER/ DEPARTMENT, WHICH HAS THE PROPER EQUIPMENT AND EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS. THROTTLE LINKAGE THROTTLE STOP 0 IDLE SPEED - Poulan HDR500E | User Manual - Page 19
TILLER • Clean entire tiller (See "CLEANING" in the Customer Responsibilities section of this manual). • Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual in your gasoline will cause problems. • If possible, store your - Poulan HDR500E | User Manual - Page 20
TROUBLESHOOTING POINTS PROBLEM Will not start Hard to . 12. Make necessary adjustments. 13. Contact an authorized service center/department. Engine overheats 1. Low oil level/dirty oil balls up or clumps 1. Ground too wet. Engine runs but tiller won't move 1. Drive control bar is not engaged. 2. - Poulan HDR500E | User Manual - Page 21
REPAIR PARTS TILLER - - MODEL NUMBER HDR500E HANDLE ASSEMBLY 2 3 4 5 25 24 22 26 6 C; 26 28 22 27 15 21 17 14 13 17 KEY PART NO. NO. DESCRIPTION 1 8389J Grip, Handle 2 121248X - Poulan HDR500E | User Manual - Page 22
REPAIR PARTS TILLER - MODEL NUMBER HDR500E MAINFRAME, LEFT SIDE • 3 •.6( 2 4 3 1. Nt 4 38 41 14/1ZiI•N'k 37 ' N 36 35 34 14N, 15 33 32 31 30\ 28 3 6 39 5 7 8 42 9 10 / 11 12 16 - Poulan HDR500E | User Manual - Page 23
REPAIR PARTS TILLER - - MODEL NUMBER HDR500E MAINFRAME, RIGHT SIDE 10 9 8 / , ).• ' ..... / I 4./.>" ..... 0 1 ....". ..' / f, "1 \\ ,-\` k "› "• *-• "" '' .. . ' II//.4 7lk\)' '' kk) 14/1) ., _.z - • .• . k . r kk) • • 1' ea \N" -„. ,V.-"-7,,.,:,0,s,/,4... - Poulan HDR500E | User Manual - Page 24
REPAIR PARTS TILLER - - MODEL NUMBER HDR500E TRANSMISSION 3 ! 2 . 15) 6 4 1 35 • 12, \d" 13 15 9 14 111011 16, 9 5 18 7 23 21 22 19 29 30 20 28 31 18 34 27 3 18 40 . 37 - Poulan HDR500E | User Manual - Page 25
REPAIR PARTS TILLER - - MODEL NUMBER HDR500E TINE SHIELD 23 24 24 23 2 34 5 10 6 7 8 9 5 12 11 18 28 25 66 11 27 26 23 23 2 4 16 b.r 22 16 16 10 19 - Poulan HDR500E | User Manual - Page 26
REPAIR PARTS TILLER - - MODEL NUMBER HDR500E TINE ASSEMBLY 2 5 4 3 3 * I - o• , .., 0 , . .....1 0 0 ..." i I. ' ----- '--4 / i• / 4* . ,t /. / // / I ' / I V / e .# ', '/' ..,/ 1 I I I I l it 6. / V / E l . 1 •.' .4 4 i'' ' 7 1 11 I • 1 ; .° • 4.- , .- - Poulan HDR500E | User Manual - Page 27
-- 156335 -- 157336 DESCRIPTION Decal, Logo Decal, Description Decal, Logo Decal, Instruction, Tilling Decal, Hand Placement Decal, Shift Indicator Dccal, Caution Decal, Briggs & Stratton Decal, Warning, Rotating Tines Decal, Reverse Decal, 5HP Manual, Owner's (English) Manual, Owner's (Spanish) 27 - Poulan HDR500E | User Manual - Page 28
Poulan
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
 |
 |
coo
itali4i1Lra,006
OWNER'S
MANUAL
MODEL
NO.
HDR500E
5
HP
17
Inch
Tiller
Assembly
•
Operation
•
Customer
Responsibilities
•
Service
and
Adjustments
•
Storage
•
Troubleshooting
•
Repair
Parts
For
Parts
and
Service,
contact
our
authorized
distributor:
call
1-800-849-1297
For
Technical
Assistance:
call
1-800-829-5886
156335
Rev.
2
6.30.97
TR
PRINTED
IN
U.S.A.