Poulan P4500F User Manual - Page 7
Helpful Tip - head
View all Poulan P4500F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
HELPFUL TIP If your engine switch reads "push to stop", it is always in the ON position. HOW TO STOP YOUR UNIT S To stop the engine, push and hold the STOP switch in the STOP position until the engine stops. S If engine does not stop, move choke lever to FULL CHOKE position. HOW TO START YOUR UNIT WARNING: The trimmer head will turn while starting the engine. Avoid any contact with the muffler. A hot muffler can cause serious burns. HELPFUL TIP If your engine still does not start after following these instructions, please call 1- 800- 554- 6723. STARTING A COLD ENGINE (or a warm engine after running out of fuel) Starting Position 1. Set unit on a flat surface. 2. Slowly press the primer bulb 6 times. 3. Move choke lever to the FULL CHOKE position. 4. Squeeze the throttle trigger fully and hold through all remaining steps. Primer Bulb Choke Lever 5. Pull starter rope handle sharply until engine sounds as if it is trying to start, but do not pull rope more than 6 times. 6. As soon as engine sounds as if it is trying to start, move choke lever to HALF CHOKE position. 7. Pull starter rope sharply until engine runs, but no more than 6 pulls. NOTE: If the engine doesn't start after 6 pulls (at the HALF CHOKE position), move the choke lever to the FULL CHOKE position and press the primer bulb 6 times. Squeeze and hold the throttle trigger and pull the starter rope 2 more times. Move the choke lever to the HALF CHOKE position and pull the start- er rope until the engine runs, but no more than 6 pulls. If the engine still doesn't start, it is probably flooded. Proceed to STARTING A FLOODED ENGINE. 8. Once the engine starts, allow it to run 10 seconds, then move the choke lever to the RUN position. Allow the unit to run for 30 more seconds at RUN before releasing the throttle trigger. NOTE: If engine dies with the choke lever in the RUN position, move the choke lever to the HALF CHOKE position and pull the rope until engine runs, but no more than 6 pulls. STARTING A WARM ENGINE 1. Move the choke lever to the HALF CHOKE position. 2. Squeeze and hold the throttle trigger. Keep throttle trigger fully squeezed until the engine runs smoothly. 3. Pull starter rope sharply until engine runs, but no more than 6 pulls. 4. Allow engine to run 15 seconds, then move the choke lever to the RUN position. NOTE: If engine has not started, pull starter rope 5 more pulls. If engine still does not run, it is probably flooded. STARTING A FLOODED ENGINE Flooded engines can be started by placing the choke lever in the RUN position; then, pull the rope to clear the engine of excess fuel. This could require pulling the starter handle many times depending on how badly the unit is flooded. If the unit still doesn't start, refer to TROUBLESHOOTING TABLE or call 1-800-554--6723. OPERATING INSTRUCTIONS It is recommended that the engine not be operated for longer than 1 minute at full throttle. Starter Handle 7