Poulan PP1130ESC User Manual

Poulan PP1130ESC Manual

Get Poulan PP1130ESC PDF manuals and user guides View all Poulan PP1130ESC manuals
Add to My Manuals
Save this manual to your list of manuals

Poulan PP1130ESC manual content summary:

  • Poulan PP1130ESC | User Manual - Page 1
    IMPORTANT MANUAL Do Not Throw Away OWNER'S MANUAL MODEL NUMBER: PP1130ESC SNOW THROWER WARNING: Read the Owner's Manual and follow all Warnings and Safety Instructions. Failure to do so can result in serious injury. Always Wear Eye Protection During Operation 192046 Rev. 1 07.29.04 BY Printed
  • Poulan PP1130ESC | User Manual - Page 2
    setting up, transporting, adjusting or making repairs. WARNING: This snow thrower is for or spark. WARNING: Snow throwers have exposed rotating parts, which can cause severe injury from contact, or from authorities. • Read the operating and service instruction manual • If snow thrower must be
  • Poulan PP1130ESC | User Manual - Page 3
    warning of trouble. • 's guide instructions for important details problem you cannot easily remedy, please contact your nearest authorized service center. We have competent, well-trained technicians and the proper tools to service or repair this unit. Please read and retain this manual. The instructions
  • Poulan PP1130ESC | User Manual - Page 4
    SAFETY RULES 2-3 PRODUCT SPECIFICATIONS 3 CUSTOMER RESPONSIBILITIES 3 WARRANTY 32 ASSEMBLY / PRE-OPERATION 5-7 OPERATION 8-13 MAINTENANCE 14-15 MAINTENANCE SCHEDULE 14 SERVICE AND ADJUSTMENTS 16-18 STORAGE 18 TROUBLESHOOTING 19 REPAIR PARTS 20-31 PARTS PACKED SEPARATELY IN CARTON 4
  • Poulan PP1130ESC | User Manual - Page 5
    / PRE-OPERATION Read these instructions and this manual in its entirety before you attempt to assemble or operate your new snow thrower. Your new snow thrower has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. All parts such as nuts, washers
  • Poulan PP1130ESC | User Manual - Page 6
    CONTROL ROD RUBBER SLEEVE AUGER CONTROL BRACKET FIG. 6 INSTALL DISCHARGE CHUTE / CHUTE ROTATER HEAD (See Fig. 7) NOTE: The multi-wrench provided in your parts bag may be used to install the chute rotater head. 1. Place discharge chute assembly on top of chute base with discharge opening toward
  • Poulan PP1130ESC | User Manual - Page 7
    ) Though seldom required, the weight bar will reduce the tendency of the auger housing to ride up on hard, icy drifts. Should conditions require it, install as follows: 1. Shut off engine and wait for all moving parts to stop. 2. Secure weight bar to auger housing with carriage bolts and hex nuts as
  • Poulan PP1130ESC | User Manual - Page 8
    yourself with the location of various controls and adjustments. Save this manual for future reference. These symbols may appear on your snow READ AND FOLLOW ALL SAFETY INFORMATION AND INSTRUCTIONS BEFORE USE OF THIS PRODUCT. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. IGNITION KEY. INSERT
  • Poulan PP1130ESC | User Manual - Page 9
    speed of snow thrower. start and run. Remove when snow thrower is not in use. Traction drive control lever - used to engage power-pro- Electric start button - used for starting the engine. pelled forward or reverse motion of snow thrower. Recoil (auxiliary) starter handle - used for starting
  • Poulan PP1130ESC | User Manual - Page 10
    shields while operating 00155 your snow thrower or performing any adjustments or repairs. We recommend standard safety glasses or a wide vision safety mask worn chute or auger become clogged, shut-off engine and wait for all moving parts to stop.Use the clean-out tool, NOT YOUR HANDS, to unclog the
  • Poulan PP1130ESC | User Manual - Page 11
    become clogged with ice and snow. Use the clean-out tool to dislodge this blockage. When cleaning, repairing, or inspecting, make certain all controls are disengaged and the auger/impeller and all moving parts have stopped. Disconnect the spark plug wire and keep the wire away from the spark plug to
  • Poulan PP1130ESC | User Manual - Page 12
    and wait for all moving parts to stop. 2. Adjust be reversed, providing additional service before requiring replacement. Replace OIL" in the Maintenance section of this manual. ADD GASOLINE (See Fig. 22) . To avoid engine problems, the fuel system See Storage Instructions for additional information
  • Poulan PP1130ESC | User Manual - Page 13
    downwind whenever possible. • Adjust the skid plates to proper height for current snow conditions. See "TO ADJUST SKID PLATES" in this section of this manual. • For extremely heavy snow, reduce the width of snow removal by overlapping previous path and moving slowly. • Keep engine clean and clear of
  • Poulan PP1130ESC | User Manual - Page 14
    instructed in this manual. Some adjustments will need to be made periodically to properly maintain your snow thrower. All adjustments in the Service and Adjustments section of this manual schedule in this manual. NOTE: Use only Original Equipment Manufacturer (OEM) parts to service this unit. Failure
  • Poulan PP1130ESC | User Manual - Page 15
    the frame with the left wheel removed, will help drain any oil trapped inside the engine. (See "TO REMOVE WHEELS" in the Service and Adjustments section of this manual). 1. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. 2. Clean area around drain
  • Poulan PP1130ESC | User Manual - Page 16
    service or adjustments: 1. Be sure throttle is in STOP position. 2. Remove safety ignition key. 3. Make sure the augers and all moving parts is discharged, see "TO CONTROL SNOW DISCHARGE" in the Operation section of this manual. SHEAR BOLTS (See Fig. 23) AUGER SHEAR BOLTS Both right and left-hand
  • Poulan PP1130ESC | User Manual - Page 17
    replaced. It is recommended that the belt(s) be replaced by a qualified service center. NOTE: It is recommended that both the auger and traction drive belt BELT COVER - See "TO REMOVE BELT COVER" in this section of this manual. 4. REMOVE ENGINE PULLEY - Remove bolt, lockwasher and flat washer securing
  • Poulan PP1130ESC | User Manual - Page 18
    engine-governed high speed needs adjusting, contact a qualified service center, which has proper equipment and experience to make any will cause problems. See engine manual. FUEL SYSTEM IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor
  • Poulan PP1130ESC | User Manual - Page 19
    TROUBLESHOOTING See appropriate section in manual unless directed to a qualified service centre. PROBLEM CAUSE CORRECTION Does not to FAST position. 5. Move to FULL position. 6. Prime as instructed in the Operation section of this manual. 7. Wait a few minutes before restarting, DO NOT prime. 8.
  • Poulan PP1130ESC | User Manual - Page 20
    will repair or replace, at our option, without charge for parts or labor incurred in replacing parts, any part which and maintained in accordance with the instructions furnished. This Warranty does not Home Products, Inc. Outdoor Products Customer Service Dept. 250 Bobby Jones Expressway Augusta,
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
OWNER'S MANUAL
MODEL NUMBER:
PP1130ESC
SNOW THROWER
Always Wear Eye Protection During Operation
IMPORTANT MANUAL
Do Not Throw Away
192046 Rev. 1
07.29.04
BY
Printed in U.S.A.
WARNING:
Read the Owner's Manual and
follow all Warnings and Safety
Instructions.
Failure to do so
can result in serious injury.