Poulan PRRT65A User Manual

Poulan PRRT65A Manual

Get Poulan PRRT65A PDF manuals and user guides View all Poulan PRRT65A manuals
Add to My Manuals
Save this manual to your list of manuals

Poulan PRRT65A manual content summary:

  • Poulan PRRT65A | User Manual - Page 1
    IMPORTANT MANUAL Do Not Throw Away OWNER’S MANUAL MODEL: PRRT65A REAR TINE TILLER WARNING: Read the Owner’s Manual and follow all Warnings and Safety Instructions. Failure to do so can result in serious injury. Always Wear Eye Protection During Operation 175680 Rev. 2 Rev. 1 8.21.01 TR Printed
  • Poulan PRRT65A | User Manual - Page 2
    Read the Owner's Manual carefully. Be Vibration is generally a warning of trouble. • Stop the engine (motor the engine and make certain all moving parts have stopped. Disconnect the spark plug wire enclosure. • Always refer to the operator's guide instructions for important details if the tiller is
  • Poulan PRRT65A | User Manual - Page 3
    . Should you experience any problems you cannot easily remedy, please contact your nearest authorized service center. We have competent, well-trained technicians and the proper tools to service or repair this unit. Please read and retain this manual. The instructions will enable you to assemble
  • Poulan PRRT65A | User Manual - Page 4
    exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tiller all parts and hardware you POSITION (See Fig. 1) When right or left hand is mentioned in this manual, it means when you are in the operating position (standing behind tiller handles
  • Poulan PRRT65A | User Manual - Page 5
    down. Insert rear carriage bolt first, with bolt head on L.H. side of tiller and loosely assemble locknut (See Fig. 5). • Insert pivot bolt in front part of plate and tighten. • Cut down remaining corners of carton and lay panels flat. • Lower the handle assembly. Tighten nut on carriage bolt so
  • Poulan PRRT65A | User Manual - Page 6
    tire pressure to 20 PSI (1.4 kg/cm2). HANDLE HEIGHT • Handle height may be adjusted to better suit operator. (See "TO ADJUST HANDLE HEIGHT" in the Service and Adjustments section of this manual). 6
  • Poulan PRRT65A | User Manual - Page 7
    with the location of various controls and adjustments. Save this manual for future reference. These symbols may appear on your Tiller engine. SHIFT LEVER - Used to shift transmission gears. SHIFT LEVER INDICATOR - Shows which gear the transmission is in. THROTTLE CONTROL - Controls engine speed.
  • Poulan PRRT65A | User Manual - Page 8
    OPERATION The operation of any tiller can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields before starting your tiller and while tilling. We recommend a wide vision safety mask for over spectacles or standard safety
  • Poulan PRRT65A | User Manual - Page 9
    the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer capacity see "PRODUCT SPECIFICATIONS" on page 3 of this manual. All oil must meet A.P.I. Service Classification SF-SJ. • Reinstall engine oil cap and tighten
  • Poulan PRRT65A | User Manual - Page 10
    REPLACEMENT" in the Service and Adjustments section of this manual). If the tiller is unusually overloaded or jammed, the shear pins are designed to break before internal damage occurs to the transmission. • If shear pin(s) break, replace only with those shown in the Repair Parts section of this
  • Poulan PRRT65A | User Manual - Page 11
    full value from the warranty, the operator must maintain tiller as instructed in this manual. Some adjustments will need to be made periodically to properly maintain your tiller. All adjustments in the Service and Adjustments section of this manual should be checked at least once each season. • Once
  • Poulan PRRT65A | User Manual - Page 12
    17) Determine temperature range expected before oil change. All oil must meet API service classification SF-SJ. • Be sure tiller is on level surface. • Oil oil. See "CHECK ENGINE OIL LEVEL" in the Operation section of this manual. AIR FILTER (See Fig. 18) Your engine will not run properly using
  • Poulan PRRT65A | User Manual - Page 13
    BLOWER HOUSING AIR SCREEN SPARK PLUG Replace spark plugs at the beginning of each tilling season or after every 50 hours of use, whichever comes first. Spark plug type and gap setting is shown in "PRODUCT SPECIFICATIONS" on page 3 of this manual. TRANSMISSION type wax. SERVICE AND ADJUSTMENTS
  • Poulan PRRT65A | User Manual - Page 14
    . 23) • Remove belt guard (See "TO REMOVE BELT GUARD" in this section of this manual). • Remove old belt by slipping off engine pulley first then remove from transmission pulley. • Place new belt in groove of transmission pulley and into engine pulley. BELT MUST BE IN GROOVE ON TOP OF IDLER PULLEY
  • Poulan PRRT65A | User Manual - Page 15
    SERVICE AND ADJUSTMENTS TINE REPLACEMENT (See Figs. 24, 25, and 26) CAUTION: Tines tines should be checked for sharpness, wear, and bending, particularly the tines which are next to the transmission. If the gap between the tines exceeds 31/2 inches (9 cm), they should be replaced or straightened
  • Poulan PRRT65A | User Manual - Page 16
    THE FACTORY HIGH SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACT YOUR NEAREST AUTHORIZED SERVICE CENTER/ DEPARTMENT, WHICH HAS THE PROPER EQUIPMENT AND EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS. FUEL TANK CLAMP SCREW CASING AND WIRE FIG
  • Poulan PRRT65A | User Manual - Page 17
    instructions in the Service and Adjustments section of this manual). • Lubricate as shown in the Customer Responsibilities section of this manual. • Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts dirt in your gasoline will cause problems. • If possible, store your
  • Poulan PRRT65A | User Manual - Page 18
    PROBLEM Will not start TROUBLESHOOTING POINTS CAUSE 1. Out of fuel. 2. Engine not "CHOKED" properly. 3. Engine flooded. 11. Clean/replace muffler. 12. Make necessary adjustments. 13. Contact an authorized service center/department. Engine overheats 1. Low oil level/dirty oil. 2. Dirty engine air
  • Poulan PRRT65A | User Manual - Page 19
    TILLER - MODEL NUMBER PRRT65A HANDLE ASSEMBLY KEY NO. 1 2 4 6 8 10 11 12 13 14 15 16 17 18 PART NO. 175250 9266R 159228 126951X , Shift Bolt, Carriage 3/8-16 x 1 Gr. 5 Lock, Handle Nut Crownlock 3/8-16 UNC KEY PART NO. NO. DESCRIPTION 19 19131611 Washer 13/32 x 1 x 11 Ga. 20 109228X Lever,
  • Poulan PRRT65A | User Manual - Page 20
    TILLER - MODEL NUMBER PRRT65A MAINFRAME, LEFT SIDE KEY PART NO. NO. DESCRIPTION 1 73510500 Nut, Keps 5/16-18 x 0.42 x 1.220 15 19111116 Washer 11/32 x 11/16 x 16 Ga. 16 145102 Sheave, Transmission 19 12000028 Ring, Retainer 21 110652X Spacer, Split 0.327 x 0.42 x 2.09 22 74770508 Bolt Fin
  • Poulan PRRT65A | User Manual - Page 21
    TILLER - MODEL NUMBER PRRT65A MAINFRAME, RIGHT SIDE 16 15 1 2 2 2 13 12 3 4 5 7 6 8 11 9 10 KEY PART NO. NO. 1 166532 2 73970500 3 19111116 4 74760512 5 102332X 6 74760532 7 102173X 8 10040600 9 73220600 10 74760524 11 4497H DESCRIPTION Bumper Locknut, Hex, Flange 5/16-18 Washer 11/32
  • Poulan PRRT65A | User Manual - Page 22
    TILLER - MODEL NUMBER PRRT65A TRANSMISSION KEY PART NO. NO. 1 170337 2 165729 3 161963 4 5020J 5 1370H 6 137335 7 145101 8 4895H 9 154467 10 7392M 11 100371K 12 106160X 13 142145 14 8353J 15 12000039 16 154466
  • Poulan PRRT65A | User Manual - Page 23
    TILLER - MODEL NUMBER PRRT65A TINE SHIELD KEY NO. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 18 PART NO. 73900500 161415X428 8393J 12000036 72140506 8394J 8392J 109230X 124289X428 72140508 73220500 10040500 72110510 124311X 161414X428 73900400 72040410 DESCRIPTION Nut, Flange 5/16-18 Shield, Side
  • Poulan PRRT65A | User Manual - Page 24
    PARTS TILLER - MODEL NUMBER PRRT65A TINE ASSEMBLY KEY NO. 1 2 3 4 5 6 7 PART NO. 4459J 132673 6554J 3146R 132727 73610600 10040600 DESCRIPTION Tine, Outer, L.H. Clevis Pin Tine, Inner, L.H. Retainer Spring Assembly, Hub and Plate, L.H. Nut, Hex 3/8-24 Washer, Lock 3/8 KEY NO. 8 9 10 11 PART
  • Poulan PRRT65A | User Manual - Page 25
    TILLER - MODEL NUMBER PRRT65A DECALS 1 2 4 6 5 7 9 14 13 11 KEY NO. 1 2 4 5 6 7 9 11 13 14 - - - PART NO. 173196 176306 136942 110614X 102180X 162384 120076X 173538 173698 173248 175680 175681 DESCRIPTION Decal, Logo,CNTRL PNL Decal, Logo, Belt Guard Decal, Instruction, Tilling Decal, Hand
  • Poulan PRRT65A | User Manual - Page 26
    SERVICE NOTES 26
  • Poulan PRRT65A | User Manual - Page 27
    option, without charge for parts or labor incurred in replacing parts, any part which we find to be , and maintained in accordance with the instructions furnished. This Warranty does not apply must return the product to an authorized service dealer. Should you have any unanswered questions concerning
  • Poulan PRRT65A | User Manual - Page 28
    pages of your phone directory for the name of the nearest service dealer (under “saws” for Chain Saws or under “lawn mowers” for Trimmers, Brushcutters, and Blowers). 3. For replacement parts, have available the following information: a. Model Number/Manufacturer's I.D. Number b. Description of
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
OWNER±S MANUAL
MODEL:
PRRT65A
REAR TINE TILLER
Always Wear Eye Protection During Operation
WARNING:
Read the Owner±s Manual and
follow all Warnings and Safety
Instructions.
Failure to do so
can result in serious
injury.
IMPORTANT MANUAL
Do Not Throw Away
175680
Rev. 2
Rev. 1
8.21.01
TR
Printed in U.S.A.