Poulan PRRT65B User Manual

Poulan PRRT65B Manual

Get Poulan PRRT65B PDF manuals and user guides View all Poulan PRRT65B manuals
Add to My Manuals
Save this manual to your list of manuals

Poulan PRRT65B manual content summary:

  • Poulan PRRT65B | User Manual - Page 1
    IMPORTANT MANUAL DO NOT THROW AWAY OWNER'S MANUAL MODEL: PRRT65B REAR TINE TILLER WARNING: Read this Owner's Manual and follow all Warnings and Safety Instructions. Failure to do so can result in serious injury. ALWAYS WEAR EYE PROTECTION DURING OPERATION 181121 Rev. 1 10.11.02 TR Printed in
  • Poulan PRRT65B | User Manual - Page 2
    Read the Owner's Manual carefully. Be Vibration is generally a warning of trouble. • Stop the engine (motor the engine and make certain all moving parts have stopped. Disconnect the spark plug wire enclosure. • Always refer to the operator's guide instructions for important details if the tiller is to
  • Poulan PRRT65B | User Manual - Page 3
    . Should you experience any problems you cannot easily remedy, please contact your nearest authorized service center. We have competent, well-trained technicians and the proper tools to service or repair this unit. Please read and retain this manual. The instructions will enable you to assemble
  • Poulan PRRT65B | User Manual - Page 4
    exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tiller all parts and hardware you POSITION (See Fig. 1) When right or left hand is mentioned in this manual, it means when you are in the operating position (standing behind tiller handles
  • Poulan PRRT65B | User Manual - Page 5
    down.Insert rear carriage bolt first, with bolt head on L.H. side of tiller and loosely assemble locknut (See Fig. 5). • Insert pivot bolt in front part of plate and tighten. • Cut down remaining corners of carton and lay panels flat. • Lower the handle assembly. Tighten nut on carriage bolt so handle
  • Poulan PRRT65B | User Manual - Page 6
    tire pressure to 20 PSI (1.4 kg/cm2). HANDLE HEIGHT • Handle height may be adjusted to better suit operator. (See "TO ADJUST HANDLE HEIGHT" in the Service and Adjustments section of this manual). 6
  • Poulan PRRT65B | User Manual - Page 7
    OPERATING YOUR TILLER. Compare the illustrations with your tiller to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. These symbols may appear on your Tiller or in literature supplied with the product. Learn and understand their
  • Poulan PRRT65B | User Manual - Page 8
    OPERATION The operation of any tiller can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields before starting your tiller and while tilling. We recommend a wide vision safety mask for over spectacles or standard safety
  • Poulan PRRT65B | User Manual - Page 9
    the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or approximate capacity see "PRODUCT SPECIFICATIONS" on page 3 of this manual. All oil must meet A.P.I. Service Classification SF-SJ. • Make sure spark plug wire is
  • Poulan PRRT65B | User Manual - Page 10
    ADJUST CARBURETOR" in the Service and Adjustments section of this manual. NOTE: If engine does not start, see troubleshooting points. CHOKE CONTROL with shear pins (See "TINE REPLACEMENT" in the Service and Adjustments section of this manual). If the tiller is unusually overloaded or jammed, the
  • Poulan PRRT65B | User Manual - Page 11
    full value from the warranty, the operator must maintain tiller as instructed in this manual. Some adjustments will need to be made periodically to properly maintain your tiller. All adjustments in the Service and Adjustments section of this manual should be checked at least once each season. • Once
  • Poulan PRRT65B | User Manual - Page 12
    burns. ENGINE LUBRICATION Use only high quality detergent oil rated with API service classification SF-SJ. Select the oil's SAE viscosity grade according to with oil. See"CHECK ENGINE OIL LEVEL" in the Operation section of this manual. OIL DRAIN PLUG OIL FILLER OIL LEVEL PLUG FIG. 17 AIR FILTER
  • Poulan PRRT65B | User Manual - Page 13
    bristled- brush. • Remove blower housing and clean as necessary. • Keep cylinder fins free of dirt and chaff. BLOWER HOUSING AIR SCREEN FIG. and gap setting is shown in "PRODUCT SPECIFICATIONS" on page 3 of this manual. TRANSMISSION Once a season, lubricate the right hand side gear case grease fitting
  • Poulan PRRT65B | User Manual - Page 14
    SERVICE AND ADJUSTMENTS CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into contact with plug. TILLER TO ADJUST HANDLE
  • Poulan PRRT65B | User Manual - Page 15
    SERVICE AND ADJUSTMENTS TO REMOVE BELT GUARD (See Fig. 22) NOTE: For ease of pulley and into engine pulley. BELT MUST BE IN GROOVE ON TOP OF IDLER PULLEY. NOTE POSITION OF BELT TO GUIDES. • Check belt adjustment as described below. • Replace belt guard. • Reposition wheel and replace clevis pin and
  • Poulan PRRT65B | User Manual - Page 16
    SERVICE AND ADJUSTMENTS TINE REPLACEMENT (See Figs. 24, 25, and 26) CAUTION: Tines are sharp. Wear gloves or other protection when handling tines. A badly worn tine
  • Poulan PRRT65B | User Manual - Page 17
    ABOVE THE FACTORY HIGH SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACTYOUR NEAREST AUTHORIZED SERVICE CENTER/ DEPARTMENT, WHICH HAS THE PROPER EQUIPMENT AND EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS. CLAMP SCREW CASING AND WIRE engine_art_78
  • Poulan PRRT65B | User Manual - Page 18
    instructions in the Service and Adjustments section of this manual). • Lubricate as shown in the Maintenance section of this manual. • Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts /or dirt in your gasoline will cause problems. • If possible, store your unit
  • Poulan PRRT65B | User Manual - Page 19
    PROBLEM Will not start TROUBLESHOOTING POINTS CAUSE 1. Out of fuel. 2. Engine not "CHOKED" properly. 3. Engine flooded 11. Clean/replace muffler. 12. Make necessary adjustments. 13. Contact an authorized service center/department. Engine overheats 1. Low oil level/dirty oil. 2. Dirty engine air
  • Poulan PRRT65B | User Manual - Page 20
    TILLER - - MODEL NUMBER PRRT65B HANDLE ASSEMBLY KEY PART NO. NO. 1 180634 2 9266R 4 159228 6 180678 Lock, Handle Nut, Crownlock 3/8-16 Unc Washer 13/32 x 1 x 11 Ga. Lever, Lock, Handle KEY PART NO. NO. DESCRIPTION 21 180517X428 Handle 23 86777 Screw, Hex Washer Hd. Slotted #10-24 x 1/2 24
  • Poulan PRRT65B | User Manual - Page 21
    TILLER - - MODEL NUMBER PRRT65B MAINFRAME, LEFT SIDE KEY PART NO. NO. DESCRIPTION 1 73510500 Nut, Keps 5/16-18 2 10040600 Guard, Belt 27 132801 Belt, V 28 104679X Pulley, Idler 29 12000032 Ring, Klip KEY PART NO. NO. DESCRIPTION 30 159229 Bracket, Idler 31 102384X Bolt, Hex 5/16-16 x
  • Poulan PRRT65B | User Manual - Page 22
    TILLER - - MODEL NUMBER PRRT65B MAINFRAME, RIGHT SIDE 16 15 1 2 2 2 13 12 3 4 5 7 6 8 11 9 10 KEY PART NO. NO. 1 166532 2 73970500 3/8 Nut, Hex 3/8-16 Bolt, Hex 5/16-18 x 1-1/2 Clip, Hairpin KEY PART NO. NO. DESCRIPTION 12 126875X Rivet, Drilled 13 5015J Tire 127259X Rim 795R Tire
  • Poulan PRRT65B | User Manual - Page 23
    REPAIR PARTS TILLER - - MODEL NUMBER PRRT65B TRANSMISSION KEY PART NO. NO. 1 180677 2 180627 3 161963 4 5020J 5 1370H 6 Includes Key Nos. 21 and 22) Gear, Reverse Idler Bearing, Needle Shaft, Reverse Idler KEY PART NO. NO. DESCRIPTION 24 10040700 Washer, Lock 7/16 25 73610700 Nut, Hex 7/16-20
  • Poulan PRRT65B | User Manual - Page 24
    TILLER - - MODEL NUMBER PRRT65B TINE SHIELD KEY PART NO. NO. DESCRIPTION 1 73900500 Nut, Lock Hex Flange 5/16-18 2 Nut, Hex Flange 1/4-20 UNC 18 72040410 Bolt, Carriage 1/4-20 x 1-1/4 Gr. KEY PART NO. NO. DESCRIPTION 19 102701X Grip 20 73220600 Nut, Hex 3/8-16 21 102156X Stake,
  • Poulan PRRT65B | User Manual - Page 25
    REPAIR PARTS TILLER - - MODEL NUMBER PRRT65B TINE ASSEMBLY KEY PART NO. NO. 1 4459J 2 132673 3 6554J 4 3146R 5 132727 6 73610600 7 10040600 DESCRIPTION Tine, Outer, L.H. Clevis Pin Tine, Inner, L.H. Retainer, Spring Zinc Assembly, Hub and Plate, L.H. Nut, Hex 3/8-24 Washer, Lock 3/8 KEY PART NO.
  • Poulan PRRT65B | User Manual - Page 26
    REPAIR PARTS TILLER - - MODEL NUMBER PRRT65B DECALS 1 2 4 5 6 7 9 14 13 11 KEY PART NO. NO. 1 173196 2 176303 4 180816 5 110614X 6 102180X 7 162384 9 120076X 11 173538 13 173698 14 173248 - - 181121 - - 181122 DESCRIPTION Decal, CNTRL PNL Decal, Decal, Blt Grd Decal, Instruction, Tilling
  • Poulan PRRT65B | User Manual - Page 27
    our option, without charge for parts or labor incurred in replacing parts, any part which we find to be , and maintained in accordance with the instructions furnished. This Warranty does not apply must return the product to an authorized service dealer. Should you have any unanswered questions
  • Poulan PRRT65B | User Manual - Page 28
    pages of your phone directory for the name of the nearest service dealer (under "saws" for Chain Saws or under "lawn mowers" for Trimmers, Brushcutters, and Blowers). 3. For replacement parts, have available the following information: a. Model Number/Manufacturer's I.D. Number b. Description of
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
OWNER'S MANUAL
MODEL:
PRRT65B
REAR TINE TILLER
ALWAYS WEAR EYE PROTECTION DURING OPERATION
181121
Rev. 1
10.11.02
TR
Printed in U.S.A.
WARNING:
Read this Owner's Manual and
follow all Warnings and Safety
Instructions.
Failure to do so can
result in serious
injury.
IMPORTANT MANUAL
DO NOT THROW AWAY