Poulan PRRT65D User Manual

Poulan PRRT65D Manual

Get Poulan PRRT65D PDF manuals and user guides View all Poulan PRRT65D manuals
Add to My Manuals
Save this manual to your list of manuals

Poulan PRRT65D manual content summary:

  • Poulan PRRT65D | User Manual - Page 1
    IMPORTANT MANUAL DO NOT THROW AWAY OWNER'S MANUAL MODEL: PRRT65D REAR TINE TILLER WARNING: Read this Owner's Manual and follow all Warnings and Safety Instructions. Failure to do so can result in serious injury. ALWAYS WEAR EYE PROTECTION DURING OPERATION 188904 11.25.03 TR Printed in U.S.A.
  • Poulan PRRT65D | User Manual - Page 2
    Practices for Walk-Behind Powered Rotary Tillers TRAINING • Read the Owner's Manual carefully. Be thoroughly familiar with the storing in any enclosure. • Always refer to the operator's guide instructions for important details if the tiller is to be stored for an extended period. - IMPORTANT
  • Poulan PRRT65D | User Manual - Page 3
    any problems you cannot easily remedy, please contact your nearest authorized service center. We have competent, well-trained technicians and the proper tools to service or repair this unit. Please read and retain this manual. The instructions will enable you to assemble and maintain your tiller
  • Poulan PRRT65D | User Manual - Page 4
    FRONT LEFT RIGHT OPERATOR'S POSITION (See Fig. 1) When right or left hand is mentioned in this manual, it means when you are in the operating position (standing behind tiller handles). OPERATOR'S POSITION FIG. 1 CONTENTS OF HARDWARE PACK (2) Handle Locks (1) Carriage Bolt 3/8-16 UNC x 1 Grade
  • Poulan PRRT65D | User Manual - Page 5
    STRETCH OR KINK CABLES. • While holding handle assembly, cut cable ties securing handle assembly to top frame and depth stake. Let handle assembly rest on tiller. • Remove top frame of carton. • Slowly ease handle assembly up and place on top of carton. • Cut down right hand front and right hand
  • Poulan PRRT65D | User Manual - Page 6
    position (See Fig. 7) • Tilt tiller forward by lifting handle. Separate cardboard cover from leveling shield. • Rotate tiller handle to the right and pull tiller out of carton. CHECK TIRE PRESSURE The operator. (See "TO ADJUST HANDLE HEIGHT" in the Service and Adjustments section of this manual). 6
  • Poulan PRRT65D | User Manual - Page 7
    to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. These symbols may appear on your Tiller or in literature supplied with the product. Learn and understand their meaning. THROTTLE CONTROL SHIFT LEVER DRIVE CONTROL BAR CHOKE
  • Poulan PRRT65D | User Manual - Page 8
    Fig. 10) The depth stake can be raised or lowered to allow you more versatile tilling and cultivating, or to more easily transport your tiller. • Move throttle control to "SLOW" position. • Place shift lever indicator in "F" (forward) position. Tines will not turn. • Lift handle to raise tines out
  • Poulan PRRT65D | User Manual - Page 9
    the tiller. Place manual. All oil must meet A.P.I. Service problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions
  • Poulan PRRT65D | User Manual - Page 10
    to choke position. • Grasp recoil starter handle with one hand and grasp tiller handle with other hand. Pull rope out slowly until engine reaches start of CARBURETOR" in the Service and Adjustments section of this manual. NOTE: If engine does not start, see troubleshooting points. CHOKE CONTROL
  • Poulan PRRT65D | User Manual - Page 11
    full value from the warranty, the operator must maintain tiller as instructed in this manual. Some adjustments will need to be made periodically to properly maintain your tiller. All adjustments in the Service and Adjustments section of this manual should be checked at least once each season. • Once
  • Poulan PRRT65D | User Manual - Page 12
    range expected before oil change. All oil must meet API service classification SF-SJ. • Be sure tiller is on level surface. • Oil will drain more freely when with oil. See"CHECK ENGINE OIL LEVEL" in the Operation section of this manual. OIL DRAIN PLUG OIL FILLER OIL LEVEL PLUG FIG. 17 AIR FILTER (See
  • Poulan PRRT65D | User Manual - Page 13
    setting is shown in "PRODUCT SPECIFICATIONS" on page 3 of this manual. TRANSMISSION Once a season, lubricate the right hand side gear case grease fi covered to keep water out. Water in engine will shorten the useful life of your tiller. • Clean engine, wheels, finish, etc. of all foreign mat- ter. •
  • Poulan PRRT65D | User Manual - Page 14
    SERVICE AND ADJUSTMENTS CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into contact with plug. TILLER TO ADJUST HANDLE HEIGHT (See Fig. 20) Select handle height best suited for your tilling conditions. Handle height will be different when tiller digs into
  • Poulan PRRT65D | User Manual - Page 15
    SERVICE AND ADJUSTMENTS TO REPLACE GROUND DRIVE BELT (See Figs. 22 and 23) • Remove and into engine pulley. BELT MUST BE IN GROOVE ON TOP OF IDLER PULLEY. NOTE POSITION OF BELT TO GUIDES. • Check belt adjustment as described below. • Replace belt guard. • Reposition wheel and replace clevis pin and
  • Poulan PRRT65D | User Manual - Page 16
    SERVICE AND ADJUSTMENTS TINE REPLACEMENT (See Figs. 24, 25, and 26) CAUTION: Tines are sharp. Wear gloves or other protection when handling tines. A badly worn tine causes your tiller to work harder and dig more shallow. Most important, worn tines cannot chop and shred organic matter as effectively
  • Poulan PRRT65D | User Manual - Page 17
    ABOVE THE FACTORY HIGH SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACTYOUR NEAREST AUTHORIZED SERVICE CENTER/ DEPARTMENT, WHICH HAS THE PROPER EQUIPMENT AND EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS. CLAMP SCREW CASING AND WIRE engine_art_78
  • Poulan PRRT65D | User Manual - Page 18
    TILLER • Clean entire tiller (See "CLEANING" in the Maintenance section of this manual). • Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual /or dirt in your gasoline will cause problems. • If possible, store your unit
  • Poulan PRRT65D | User Manual - Page 19
    TROUBLESHOOTING POINTS PROBLEM Will not start CAUSE up or clumps 1. Ground too wet. Engine runs but tiller won't move 1. Drive control bar is not engaged. muffler. 12. Make necessary adjustments. 13. Contact an authorized service center/department. 1. Check oil level/change oil. 2. Clean engine
  • Poulan PRRT65D | User Manual - Page 20
    REPAIR PARTS TILLER - - MODEL NUMBER PRRT65D HANDLE ASSEMBLY 8 6 2 30 2 33 41 27 1 29 37 37 4 26 24 23 KEY PART NO. NO. 1 180634 2 9266R 4 159228 6 180678 8 71191008 10 8206H 11 4497H
  • Poulan PRRT65D | User Manual - Page 21
    REPAIR PARTS TILLER - - MODEL NUMBER PRRT65D MAINFRAME, LEFT SIDE 7 6 39 8 9 10 1 5 32 32 11 12 13 65 37 36 14 33 32 21 4 38 16 35 34 31 29 22 27
  • Poulan PRRT65D | User Manual - Page 22
    REPAIR PARTS TILLER - - MODEL NUMBER PRRT65D MAINFRAME, RIGHT SIDE 16 15 1 2 2 2 13 12 3 4 5 7 8 11 9 10 KEY PART NO. NO. 1 185190 2 73970500 3 19111116 4 74760512 5 102332X 6 74760528 7 102173X 8 10040600 9 73220600 10 74760524 11
  • Poulan PRRT65D | User Manual - Page 23
    REPAIR PARTS TILLER - - MODEL NUMBER PRRT65D TRANSMISSION 12 9 11 13 15 10 16 60 48 9 14 8 5 7 18 23 6 21 22 45 18 19 29 20 31 30 40 18 18 34
  • Poulan PRRT65D | User Manual - Page 24
    REPAIR PARTS TILLER - - MODEL NUMBER PRRT65D TINE SHIELD 1 34 10 13 2 6 14 7 5 29 8 30 18 28 23 24 33 25 23 32 10 10 9 12 11 10 12 16 12 27
  • Poulan PRRT65D | User Manual - Page 25
    REPAIR PARTS TILLER - - MODEL NUMBER PRRT65D TINE ASSEMBLY 2 1 1 1 3 5 1 4 3 67 11 11 2 9 8 KEY PART NO. NO. 1 4459J 2 132673 3 6554J 4 3146R 5 132727 6 73610600 7 10040600 DESCRIPTION Tine, Outer, L.H. Clevis Pin Tine, Inner, L.H. Retainer, Spring
  • Poulan PRRT65D | User Manual - Page 26
    REPAIR PARTS TILLER - - MODEL NUMBER PRRT65D DECALS 1 2 4 5 6 7 9 14 13 11 KEY PART NO. NO. 1 173196 2 189872 4 180816 5 110614X 6 102180X 7 162384 9 120076X 11 173538 13 173698 14 173248 - - 188904 - - 188905 DESCRIPTION Decal, CNTRL PNL Decal, Decal, Blt Grd Decal, Instruction, Tilling
  • Poulan PRRT65D | User Manual - Page 27
    assembled, adjusted, operated, and maintained in accordance with the instructions furnished. This Warranty does not apply to any product which under this Warranty, you must return the product to an authorized service dealer. Should you have any unanswered questions concerning this Warranty, please
  • Poulan PRRT65D | User Manual - Page 28
    PARTS AND SERVICE Your POULAN PRO product has been expertly engineered and carefully manufactured to rigid quality standards. As with all mechanical products, some adjustments or part replacement may be necessary during the life of your unit. FOR SERVICE OR REPLACEMENT PARTS: 1. Consult your dealer
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
OWNER'S MANUAL
MODEL:
PRRT65D
REAR TINE TILLER
ALWAYS WEAR EYE PROTECTION DURING OPERATION
188904
11.25.03
TR
Printed in U.S.A.
WARNING:
Read this Owner's Manual and
follow all Warnings and Safety
Instructions.
Failure to do so can
result in serious
injury.
IMPORTANT MANUAL
DO NOT THROW AWAY