ProForm 695 Pi Treadmill English Manual - Page 11
How To Use The Manual Mode
View all ProForm 695 Pi Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
HOW TO TURN ON THE POWER Note: To prevent damage to the walking platform, always wear clean shoes when using the treadmill. Plug in the power cord (see page 9). Next, locate the reset/off circuit breaker near the power cord. Make sure that the circuit breaker is in the reset position. Reset Position Stand on the foot rails of the treadmill. Find the clip attached to the key (see the drawing on page 10), and slide the clip onto the waistband of your clothes. Next, insert the key into the console. The display will light. Important: In an emergency situation, the key can be pulled from the console, causing the walking belt to slow to a stop. Test the clip by carefully taking a few steps backward; if the key is not pulled from the console, adjust the position of the clip. HOW TO USE THE MANUAL MODE 1 Insert the key into the console. See HOW TO TURN ON THE POWER above. 2 Select the manual mode. When the key is in- serted, the manual mode will be selected. Track If a program has been selected, reselect the manual mode by pressing the Program Select button repeatedly until a track appears in the lower part of the dis- play. 3 Start the walking belt. To start the walking belt, press the Start button, the Speed increase button, or one of the speed buttons numbered 1 to 10. If the Start button or the Speed increase button is pressed, the walking belt will begin to move at 1 mph. As you exercise, change the speed of the walking belt as desired by pressing the Speed increase and decrease buttons. Each time a button is pressed, the speed setting will change by 0.1 mph; if a button is held down, the speed setting will change in increments of 0.5 mph. Note: After the buttons are pressed, it may take a moment for the walking belt to reach the selected speed setting. If one of the speed buttons numbered 1 through 10 is pressed, the walking belt will gradually increase in speed until it reaches the selected speed setting. To stop the walking belt, press the Stop button. To restart the walking belt, press the Start button, the Speed increase button, or one of the speed buttons numbered 1 through 10. Note: The first time the treadmill is used, observe the alignment of the walking belt, and align the walking belt if necessary (see page 20). 4 Change the incline of the treadmill as desired. To change the incline of the treadmill, press the Incline increase and decrease buttons. Each time a button is pressed, the incline will change by 0.5%. Note: After the buttons are pressed, it may take a moment for the treadmill to reach the selected incline setting. 5 Follow your progress with the display. When the manual mode is selected, the lower part of the display Track will show a track that represents 1/4 mile. As you walk or run, the indica- tors around the track will appear in succession until the entire track appears. The track will then disappear and the indicators will again begin to ap- pear in succession. 11