ProForm 695 Pi Treadmill English Manual - Page 16
The Optional Chest Pulse Sensor
View all ProForm 695 Pi Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
THE INFORMATION MODE/DEMO MODE THE OPTIONAL CHEST PULSE SENSOR The console features an information mode that keeps track of the total number of hours that the treadmill has been operated and the total number of miles that the walking belt has moved. The information mode also allows you to select miles or kilometers as the unit of measurement and to turn on and turn off the demo mode. An optional chest pulse sensor adds even more features to the console. The chest pulse sensor offers hands-free operation, and enables you to use the console's two heart rate programs. To purchase the optional chest pulse sensor, call the toll-free telephone number on the front cover of this manual. To select the information mode, hold down the Stop button while inserting the key into the console. When the information mode is selected, the following information will be shown in the display: The center of the display will show the total number of miles (or kilometers) that the walking belt has moved and the total number of hours Miles Hours that the treadmill has been used. An "E" for English miles or an "M" for metric kilo- meters will appear in the right side of the display. Press the Speed increase button to change the unit of mea- surement if desired. IMPORTANT: If a "d" appears in the right side of the display, the console is in the "demo" mode. This mode is intended to be used only when a treadmill is displayed in a store. When the console is in the demo mode, the power cord can be plugged in, the key can be removed from the console, and the indicators in the display will automatically appear in a preset sequence, although the buttons on the console will not operate. If a "d" appears when the information mode is selected, press the Speed decrease button so "d" disappears. If you purchase the optional chest pulse sensor, follow the steps below to install the receiver included with the chest pulse sensor. 1. Make sure that the key is removed from the console and that the power cord is unplugged. Remove the indicated Screw (3) and the Access Door (76) from the back of the Console Base (85). 2. Connect the wire on the receiver (A) to the indicated wire extending from the Console Base (85). Hold the receiver so the small cylinder is oriented as shown and is facing the Console Back. Attach the receiver to the plastic posts on the Access Door (76) with the two included small screws. To exit the information mode, remove the key from the console. 3. Make sure that no wires are pinched. Reattach the Access Door (76) with the Screw (3). Discard the other wires included with the receiver. 85 76 3 Wire Small Screws A Small Cylinder 16