ProForm Lx470 Treadmill English Manual - Page 8
Damaged When The Power Is Turned On.
View all ProForm Lx470 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
5. Place the Console Base (46) on the Right Handrail (47) 5 and the Left Handrail (not shown). Attach the Console Base with four 3/4" Screws (13) (only two Screws are shown). Do not tighten the Screws yet. Insert the Wire Harness (21) through the two indicated plastic ties on the Console Base (46). Next, insert the Wire Harness up through the opening beside the Console Cover (96). Make sure that the Console Cover is securely attached to the Console Base. 13 See the inset drawing. Look at the top of the Console Base (46). Insert the Wire Harness (21) through the plastic tie on top of the Console Base. 46 21 96 Ties 47 21 Tie 46 6. Hold the Console (10) near the Console Base (46). Touch the Right Handrail (47) to discharge any static. See the inset drawing. Find the 3-wire connector on the end of the Wire Harness (21). Insert the connector into the red socket beneath the console. The connector should slide easily into the socket and snap into place. If the connector does not slide easily and snap into place, turn the connector and then insert it. Insert the 5-wire connector into the black socket beneath the console in the same way. Insert the excess Wire Harness (21) down through the opening in the Console Base (46 [see the inset drawing in step 5]). Securely tighten the plastic tie on top of the Console Base to prevent the Wire Harness from slipping. Then, cut off the end of the plastic tie. Make sure that the connectors and wires appear as shown at the right. IF THE CONNECTORS ARE NOT INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. See drawing 6a. Press the Bookrack (90) onto the Console Base (46) in the location shown. Set the Console (10) on the Console Base (46). Insert the excess Wire Harness (21) into the large hole in the side of the Right Handrail (47). Securely tighten the plastic ties on the bottom of the Console Base to prevent the Wire Harness from slipping. Then, cut off the ends of the plastic ties. Attach the Console (10) to the Console Base (46) with four 3/4" Screws (13) and two 1/2" Silver Screws (97). Start all six Screws before tightening them; do not overtighten the Screws. 6 21 10 Ties 46 13 47 97 13 21 3-wire 5-wire 6a 90 46 8