Pyle PCLRMU2 PCLRMU2 Manual 1

Pyle PCLRMU2 Manual

Pyle PCLRMU2 manual content summary:

  • Pyle PCLRMU2 | PCLRMU2 Manual 1 - Page 1
    body type for Walking/Running style. PERSONAL TRAINER Thank you for choosing Pyle as your personal trainer. In order to make the best use of this device, please read the instruction manual carefully. Do not discard keep the manual for future reference. Important: Please note that the watch is NOT
  • 1

3
IMPORTANT!
For energy saving purposes, the watch unit will automatically switch off if no
buttons are pressed for 3 minutes. To turn it on again, press any keys or
sensor receive motion. The pedometer mode will also be off during
transportation for energy saving purposes.
IDEAL PLACEMENT
NORMAL WALKING MEASUREMENT
Before you track the number of steps you take as you go about your normal
daily life, you need to preset the following personal information before using
the unit.
The Units You Want To Use
Your Normal Walking Stride Length
Your Current Weight
Set your Target Distance
MODE FLOW
STEP COUNTING MODE - DISTANCE MODE - CALORIES BURNT MODE
- EXERCISE TIME MODE - MEMORY DATA MODE - TOTAL
MODE
STEP COUNTING MODE
1.Press MODE button until you have reached
the STEP data with the clock.
4
2.The unit may take a bit of time before it starts to sense that you are walking.
During that time, it will not display a step count. Once the watch determines
that you are walking, it will display your entire step count from the beginning
of your walk, including the steps you took while the watch was not displaying
a step count. This is the intelligent step filter system to prevent the inclusion
of false motion.
3.The step counting data are saved automatically at midnight each day and
all data are cleared to zero. Note that the unit only maintains the last seven
days of data, so the earliest data is deleted automatically whenever data
excess from 8 days is saved. We recommend user to upload the data to
PC weekly.
4.To clear the daily step counting, press and hold Reset/+ button for 3 seconds
CALORIES BURNT MODE
1. Press the MODE button until you have reached
the Calories Burnt Mode
2. To clear the calories data, press and hold
Reset/+ button for 3 seconds
DISTANCE MODE
1. Press the MODE button until you have reached
the Distance Mode.
2. To clear the daily distance, press and hold
Reset/+ button for 3 seconds
5
EXERCISE TIME MODE
1. Press the MODE key until you have reached
the Exercise Time Mode
2. To clear the exercise time, press and hold
Reset/+ button for 3 seconds
Note:
Removal of any of the above set of data
will remove all the data for that day.
MEMORY DATA MODE
1. Press the MODE key until you have reached
the Memory Data Mode
2. Press Reset/+Set Button to select the date you
want to view
3. Press Set Button to view the data :
Step - Distance - Calories Burnt - Exercise Time
TOTAL MODE
1. Press the MODE key until you have reached the
Total Mode
2. Press Set Button to view the data :
Total Step - Total Distance - Total Calories Burnt-
Total Exercise Time
3. To clear all the data ( include daily step counting
& memory data mode ), press and hold Reset/+
button for 3 seconds
6
USER SETTING
Time Setting
1. Press the MODE key until you have reached
the Step Counting Mode
2. Press and hold Set Button for 3 seconds to set
the
TIME FORMAT
3. Press MODE/- or RESET/+ button to change
the format
4. Press the SET button to enter next setting
-
HOUR
5. Press MODE/- or RESET/+ button to increment
or decrement the setting data
6. Press the SET button to enter next setting
-
MINUTE
7. Press MODE/- or RESET/+ button to increment
or decrement the setting data.
7
8. Press the SET button to enter next setting
-
UNIT
9. Press MODE/- or RESET/+ button to select
CM or INCH
10. Press the SET button to enter next setting
-
STRIDE LENGTH
11. Press MODE/- or RESET/+ button to increment
or decrement the setting data.
(Default:80cm/30", Range:30-213cm/12"-84")
12. Press the SET button to enter next setting
-
WEIGHT
13. Press MODE/- or RESET/+ button to increment
or decrement the setting data. (Default:
45kg/100lb, Range:20-227kg/50-500lbs)
14. Press the SET button to enter next setting
-
TARGET STEP
15. Press MODE/- or RESET/+ button to
increment or decrement the setting data.
(Default:5,000 steps, Range:0-99,000
steps)
16. The adjustment should be 1,000 steps
for each increment or decrement, when
target is below 1,000 steps, it will become
100 steps for each adjustment
8
17. There are 10 icons show the percentage of
your step to target steps. When you finished
the target steps (100%), the icon will be full
of 10 icons and will flash together with a
beeping alarm for 30 seconds
Note:
No buttons pressed or held for 60 seconds will automatically trigger the unit
to return to step counting mode.
DOWNLOADING/INSTALLATING PC-LINK PROGRAM
Please visit our website at http://www.anyrun.com/k515m.htm to
download the interface program or from the provided CD
PROGRAM PROVIDES:
Full processing and analysis of your exercise data
History of your personal training data
Graphical analysis of data information
Email data file with Excel Format
9
PC-LINK PROGRAM OPERATION
First User:
Click " New " button to create a new USER NAME and enter your personal
information then save it for confirmation
PC LINK COMMUNICATION
1. Unit will automatically upload the data to PC
once plugged into the computer
2. Login the program and enter to the Main Screen
3. Click any button to select the desired report or data.
Step - Distance - Calories - Exercise Time
4. Press the SEND button to export the excel data file by email.
10
11
12
Diagram 1
SCREW
BACK COVER
CR2032
BATTERY
INSTALLING THE BATTERY
The Watch uses 1 piece CR 2032 batteries. Use only the recommended
batteries.
NOTE
: Changing the battery will erase the data in the watch previously input
into the device and you can then/will need to re-set the watch all over again.
1. The battery compartment is located at the back of the unit
2. To install/replace the battery, unscrew the battery compartment with the
screw driver and simply slide afterwards
3. Take out the old battery and dispose of properly
4. Gently place a new battery into the battery slot of the battery compartment,
make sure that the poles are correctly placed
Screw back the battery compartment, when finished as in the diagram below
13
IMPORTANT BATTERY INFORMATION
Battery installation and removed should be performed by an adult
Use only batteries recommended in this instruction sheet
Be sure to install the batteries with the correct polarity, as indicated
Remove all batteries when replacing the old batteries with new
batteries
Only batteries of the same and equivalent type as recommended
are to be used
Do not short-circuit the supply terminals
Exhausted batteries should be removed from the product
Non-rechargeable batteries are not to be recharged
Rechargeable batteries are to be removed from the product before
being charged
Rechargeable batteries are only to be charged under adult supervision
Different types of batteries, new and used batteries are not to be
mixed.
SPECIFICATIONS
Time Format:
Hour, Minute, 12/24 hours
Features:
Step Counting, Distance, Calories
Consumption, Exercise time
Measurement Range:
Calories Consumption: 0-9999.9 kcal
Number of step: 0-99999
Distance:0-999.99 km/999.99 Mile
Exercise Time: 0-23 hr 59 m 59 s 99
Memory Date:
7 Memory Records
14
CAUTION
Should you encounter any problems with the unit (e.g. malfunctioning of a
parameter, static electricity, interferences within the product or the need to
re-set the device), please press four buttons at the same time to reset the
unit (the unit should not connect with computer). All data previously input into
the device will be erased and you can then/will need to re-set the unit all over
again. Should this fail to correct the situation, remove the batteries and then
put them back into the battery compartment.
Then follow all the steps mentioned above in order to input the necessary
data once more. The content of this manual is subject in order to change
without further notice. Due to printing limitation, the displays shown in this
manual may differ from the actual display. The manufacturer and its suppliers
hold no responsibility to you or any other persons for any damage expenses,
lost-profits, or any other claims arisen by using this product. The contents of
this manual may not be reproduced without the permission of the manufacturer.
SET
EL
MODE/-
RESET/+
USB CALORIES MONITOR
This unit is operated by four keys:
MODE / -
RESET / +
SET
EL
FEATURES:
Time
Intelligent Step Filter Function
7 Days Data Memory Record
Target Step Alert Alarm
Exercise Time
Total Distance
Total Calories
User Setting
USB PC Link Interface Program
Low Battery Detection
Energy Saving Function
2
3D SENSOR FROM USA - MEASURES YOUR MOVEMENT ACCURATELY
- The 3D technology in the accelerator is an accelerometer sensor that
detects and measures acceleration in walking or running.
- 3D Sensor has intelligent step filter function-steps which only starts
counting when the unit detects continuous movement for over 10 seconds.
- 3D Sensor allows users to customize to their specific body type for
Walking/Running style.
PERSONAL TRAINER
Thank you for choosing Pyle as your personal trainer. In order to make
the best use of this device, please read the instruction manual carefully.
Do not discard keep the manual for future reference.
Important:
Please note that the watch is NOT a medical device and is not
to be used as such.
CONTENTS
Getting Start
...........................................................................................
Using the unit function
.............................................................................
Mode Flow
..............................................................................................
Step Counting Mode
................................................................................
Distance Mode
.........................................................................................
Calories Burnt Mode
................................................................................
Exercise Time Mode
................................................................................
Memory Data Mode
.................................................................................
Total Mode
...............................................................................................
User Setting
.............................................................................................
Download/Installation PC-Link Program
..................................................
PC-Link Program Operation
....................................................................
Installing the Battery
................................................................................
Specification
............................................................................................
Caution
....................................................................................................
2
3
3
3
4
4
5
5
5
6
8
9
12
13
14
Des
Male
Name
Gender
Welcome to ANYRUN! Please select user.
New
Del
OK
73-258-0001
PCLRMU2
www.pyleaudio.com