Pyle PKBRTP100.5 Instruction Manual
Pyle PKBRTP100.5 Manual
 |
View all Pyle PKBRTP100.5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Pyle PKBRTP100.5 manual content summary:
- Pyle PKBRTP100.5 | Instruction Manual - Page 1
into spear body, make sure the connection is proper and tight. Remark: Improper connection would cause leakage of beer. PKBRTP50 PKBRTP100 UNIT OPERATION INSTRUCTIONS 4. Cut beer hose according to keg height and insert into spear, make sure hose can touch bottom of keg without overlong or over - Pyle PKBRTP100.5 | Instruction Manual - Page 2
expected if pressure remains. 8. Turn the regulator knob o and install a new capsule into the regulator by following above steps PART THREE: TROUBLE SHOOTING GUIDE 1. Faucet Leakage: Solution: Please screw out and remove the faucet and install again, make sure the faucet matches the connection of
-
1 -
2
 |
 |
by
www.NutrichefKitchen.com
www.NutrichefKitchen.com
Homebrew
Mini Keg System
PKBRTP100
PKBRTP50
UNIT OPERATION INSTRUCTIONS
PART ONE: SPEAR ASSEMBLY
1. Please clean mini-keg, cap, spear body, faucet and beer
hose with warm water and mild
soap before use.
1. Spear Body
2. Cross-bar
3. Twist Tube
4. Pressure Relieving Ring
5. Nut
6. White
Flow-control Block
7. Faucet
8. Faucet Knob
9. Regulator
10. Regulator Base
11. Regulator Knob
12. Gauge
13. 16g C02 Capsule
14. Beer Hose
2. Insert white
flow-control block into cross-bar, it would
limit the beer flow and reduce over-foam.
3. Install faucet into spear body, make sure the connection is
proper and tight.
Remark:
Improper connection would cause leakage of beer.
4. Cut beer hose according to keg height and insert into
spear, make sure hose can touch bottom of keg without
overlong or over short.
Remark:
If beer hose is too short, beer would not be tapped
completely. But if beer hose is too long, it may crimp inside
the keg, because of incomplete tapping.
5. Check whether the regulator knob is in OFF position.
If not, please follow arrow mark instruction to turn the
regulator knob counter clockwise to the OFF position.
2. Insert white
flow-control block into cross-bar, it would
limit the beer flow and reduce over-foam.
6. Turn in a new 16g C02 capsule with thread type of 3/8"-24
UNF, turn clockwise firmly into the regulator base.
Important:
DON'T stop turning if you hear a slight gas leak
swish, finish turning it in all the way it seal properly.
PART TWO: TAPPING
1. Attach the spear system to the
keg. Make sure they are as tight
as possible to avoid lessening
or leakaging.
2. Connect the regulator to the spear system