Pyle PKNESPRESO70 Instruction Manual

Pyle PKNESPRESO70 Manual

Get Pyle PKNESPRESO70 PDF manuals and user guides View all Pyle PKNESPRESO70 manuals
Add to My Manuals
Save this manual to your list of manuals

Pyle PKNESPRESO70 manual content summary:

  • Pyle PKNESPRESO70 | Instruction Manual - Page 1
    PKNESPRESO70 Espresso Machine & Milk Frother Automatic Capsule Espresso Maker with Hot & Cold Milk Frother
  • Pyle PKNESPRESO70 | Instruction Manual - Page 2
    is essential to follow them and the operating instructions. • First read this entire operating manual. • Danger of electric shock! Never immerse of electric shock! Damaged power cables may only be replaced at the customer service centre. • Danger of electric shock! Never touch the power plug/socket/
  • Pyle PKNESPRESO70 | Instruction Manual - Page 3
    *In such cases immediately have the machine checked and repaired if necessary at the customer service centre. • The machine location must meet the following requirements: *Choose a dry, stable and level support surface not immediately underneath the power point at least 60 cm away from the washbasin
  • Pyle PKNESPRESO70 | Instruction Manual - Page 4
    ! Tip: Keep the packaging for transporting the machine (e.g. for removals, servicing, etc.) Note: You may find little water remaining in the machine and can be lethal. Please pay attention to the safety precautions in this manual, in particular the following: • Danger of scalding: beware of hot water
  • Pyle PKNESPRESO70 | Instruction Manual - Page 5
    • Do not open the handle when the machine is brewing. • Always pull out the power plug before cleaning the machine. • Only use the machine in a dry room. • Thoroughly rinse out the water tank with fresh water before using for the first time. Clean the Capsule co ee machine using a damp cloth only.
  • Pyle PKNESPRESO70 | Instruction Manual - Page 6
    HOW TO COMBINE THE COFFEE MACHINE WITH MILK FROTHER 1 2 Put the PKNESPRESO70 on a at surface. Insert the milk frother base in this hole. 3 4 Use one hand to slant the co ee machine a little and use the other
  • Pyle PKNESPRESO70 | Instruction Manual - Page 7
    5 6 It shows the base is already Then put the machine on a at connected with the co ee machine surface. 7 8 Put the milk frother on the base according to the arrow on the picture. Plug the power cord into the electrical outlet, you will hear a beep sound once you put on the milk frother. 7
  • Pyle PKNESPRESO70 | Instruction Manual - Page 8
    Machine Parts and Controls Overview MILK FROTHER 8 www.NutrichefKitchen.com
  • Pyle PKNESPRESO70 | Instruction Manual - Page 9
    ESPRESSO MACHINE A Short espresso button B Normal Lungo espresso Espresso C button button D E Adjustable dispenser spout (2 positionsĎ No. name A handle B bu�ons C Dispenser D Drip tray set E wall F Water tank G water tank (removable) H Power cord I Main switch J Used capsule container K
  • Pyle PKNESPRESO70 | Instruction Manual - Page 10
    ESPRESSO MACHINE Definition of Lighting name status indicator Bu�on light Light in used capsule container func�on ac�on First use. Light steady/Water tank is empty. Light steady Refer to "flash out the machine and internal circuit" Fill up water tank, open handle, then press any bu�on to fill
  • Pyle PKNESPRESO70 | Instruction Manual - Page 11
    USING THE MILK FROTHER Function Whisk option To make cold, frothed milk Max capacity (marked with circle) Time ~80~100s To make hot, frothed milk To heat milk ~130~180s 11 www.NutrichefKitchen.com
  • Pyle PKNESPRESO70 | Instruction Manual - Page 12
    1. Choose the appropriate whisk and insert it on the whisk head inside the jug. (see the table above for reference). 2. Pour milk into the jug according to the max & min markings. (See the max capacity for each whisk type above for reference), place the jug on power base. Place the lid securely 3.
  • Pyle PKNESPRESO70 | Instruction Manual - Page 13
    USING THE ESPRESSO MACHINE Fill / Refill Water Tank There are two ways to fill the water tank: Directly into the machine, by using for example a jug, or by removing the water tank. Filling without removing the tank • Raise the water tank lid • Fill the tank up to the "MAX" mark with cold fresh water (
  • Pyle PKNESPRESO70 | Instruction Manual - Page 14
    The lights on the control buttons are blinking, blue lights in used-capsule container is lighted in blue which goes o after 1 minute Tips: You can check easier if the used container is full or not when the blue light is ON. The indicator will blink in red for first use, meaning the internal circuit
  • Pyle PKNESPRESO70 | Instruction Manual - Page 15
    Brewing Co ee *Make sure the water tank is in place before brewing. Because there is hot cleaning water come out during heating up. CAUTION HOT WATER RISK OF SCALDING 1. Place an empty cup under the dispenser. For small cups, low down the dispensing spout. 2. Move the handle back completely 3.
  • Pyle PKNESPRESO70 | Instruction Manual - Page 16
    Energy saving mode. The machine enters energy saving model automatically once the machine is idle for 15 minutes. The 3 buttons will flash cyclically in energy saving mode. To access quiet energy saving mode, please press any button, appliance will start warming up with lights blinking, when the
  • Pyle PKNESPRESO70 | Instruction Manual - Page 17
    significantly or after one or two months. Decalcification must be done correctly to prevent damage. So it is essential to follow these instructions. Important: • Never clean the machine with vinegar. This causes damage and makes your co ee taste bad. • Damage caused by incorrect decalcification or
  • Pyle PKNESPRESO70 | Instruction Manual - Page 18
    ) to clean the internal circuit completely. Factory Reset In case you want to have the default setting of the machine, please follow below instruction a. Turn o the machine. b. Press the lungo button and keep the button pressed, then switch ON the machine simultaneously, release the button after
  • Pyle PKNESPRESO70 | Instruction Manual - Page 19
    Steaming out / Storage / Transport Steaming Out • Prior to long periods of disuse or for storage or transport at temperatures below 41°F, it is essential to steam out the machine. This removes water from the system to prevent internal frost damage. • Turn ON the machine • Empty the water tank and
  • Pyle PKNESPRESO70 | Instruction Manual - Page 20
    parts. Do not try to x it by yourself. Refer it to a quali ed appliance repair technician if servicing is needed. Care & Cleaning Instructions NOTE: To reduce build-up of milk residues, always empty any residual milk and clean immediately after frothing completed. Never leave liquid in the
  • Pyle PKNESPRESO70 | Instruction Manual - Page 21
    TROUBLESHOOTING MILK FROTHER ISSUES Not be able to start SOLUTIONS Check the power is at 6~10 degree. The unit is hot after operation, cool it down by filling tap water into jug. Call service line. Check if proper quantity of milk was added corresponding to the whish. ESPRESSO MACHINE No coffee is
  • Pyle PKNESPRESO70 | Instruction Manual - Page 22
    not placed well in 1)Change the Capsules. brewing chamber. 2)Push the Capsule a li�le deeper to align with the Capsule chamber. PKNESPRESO70 Espresso Machine & Milk Frother Automatic Capsule Espresso Maker with Hot & Cold Milk Frother Espresso Maker Features: • Countertop Espresso Maker • Brew
  • Pyle PKNESPRESO70 | Instruction Manual - Page 23
    Milk Frother Features: • 2-in-1 Milk Frother & Warmer • Choose Your Froth: Creates Hot or Cold Milk Froth! • Simple Electric Plug-in Design • Sleek, Modern Kitchen Style • Quick Heat Ability, Warms in Seconds • Transparent Lid to see the Frothing • LED Indicator Light • Convenient Grip Handle •
  • Pyle PKNESPRESO70 | Instruction Manual - Page 24
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
Espresso Machine & Milk Frother
PKNESPRESO70
Automatic Capsule Espresso Maker with Hot & Cold Milk Frother