Pyle PLMCWD25 Instruction Manual
Pyle PLMCWD25 Manual
View all Pyle PLMCWD25 manuals
Add to My Manuals
Save this manual to your list of manuals |
Pyle PLMCWD25 manual content summary:
- Pyle PLMCWD25 | Instruction Manual - Page 1
Always on the watch...Even if you're not! MOTORCYCLE ALARM MANUAL - Pyle PLMCWD25 | Instruction Manual - Page 2
2 - Pyle PLMCWD25 | Instruction Manual - Page 3
NOTICE t Please have system installed by an authorized dealer. t Protect this product and its transmitters from humidity and water. t Read manual carefully before installing and operating the unit. t Replace battery when the transmitter's operating distance is shortened or its indicator lights dim - Pyle PLMCWD25 | Instruction Manual - Page 4
FUNCTIONS ARMING OPERATION To arm the system press transmitter button 1: t The siren will chirp once. t The parking lights will once.* t The LED will rapidly then start slow- ly. After 8 seconds the system is armed (2-way only). While armed, the system will trigger if: t If alarm detects a - Pyle PLMCWD25 | Instruction Manual - Page 5
FUNCTIONS * Optional feature REMOTE ENGINE START (PLMCWD25/75) Press button 3 twice, the engine will start and run for 8 minutes. Engine will turn off after 8 minutes and alarm will return to previous status. During the 8 minutes, if you insert the key and turn to ON, the engine will keep running. - Pyle PLMCWD25 | Instruction Manual - Page 6
FUNCTIONS sensitivity (level 8=most sensitive), which can be adjusted using the remote transmitter. To adjust the system's built-in shock sensor: 1. Make sure the system is disarmed and ignition is turned off. 2. Press and hold unlock and lighting bolt buttons together to enter adjust mode. t The - Pyle PLMCWD25 | Instruction Manual - Page 7
PLMCWD15/PLMCWD25/PLMCWD75 - INSTALLATION DIAGRAM 7 - Pyle PLMCWD25 | Instruction Manual - Page 8
ECU INSTALLATION Please mount the ECU downside as shown in the figure. LED INSTALLATION IGNITION DEFEAT WIRE DIAGRAM +12V IGNITION (MOTOR SIDE) TO GREY IGNITION DEFEAT WIRE ON ECU 86 87 87a 85 30 +12V IGNITION (KEY SIDE) SIREN INSTALLATION Mount the siren downward as shown in figures 1 or 2 - Pyle PLMCWD25 | Instruction Manual - Page 9
TROUBLESHOOTING 1). Transmitter is ineffective or the control distance decreased improperly connected. t The siren is damaged. 5) If the problem persists, please follow these steps t For consumer: contact your dealer or nearby service center. t For installer or dealer: email your question to - Pyle PLMCWD25 | Instruction Manual - Page 10
NOTES 10 - Pyle PLMCWD25 | Instruction Manual - Page 11
Always on the watch...Even if you're not! 11 - Pyle PLMCWD25 | Instruction Manual - Page 12
www.pyleaudio.com 12 PLCWD_2Way_Manuals.qxd 06/03/14
MOTORCYCLE ALARM
MANUAL
Always on the watch...Even if you’re not!