Pyle PLUTV58BKA Instruction Manual
Pyle PLUTV58BKA Manual
 |
View all Pyle PLUTV58BKA manuals
Add to My Manuals
Save this manual to your list of manuals |
Pyle PLUTV58BKA manual content summary:
- Pyle PLUTV58BKA | Instruction Manual - Page 1
Questions? Issues? We are here to help! Phone: (1) 718-535-1800 Email: [email protected] PLUTV58BKA 5.25'' Waterproof Marine Speakers + 2 Ch. Rated Amplifier +Wireless BT Audio Controller ATV, UTV, 4x4, Jeep, Wired RCA, for Boat Stereo Speaker and Other Watercraft (1000W) - Pyle PLUTV58BKA | Instruction Manual - Page 2
reasons, keep the volume of your audio system moderate so that you can still hear normal traffic sounds in a reasonable distance. WIRING INSTRUCTIONS POWER CONNECTION The battery terminal (BATT) must be connected directly to the positive terminal of the vehicle battery to provide an adequate voltage - Pyle PLUTV58BKA | Instruction Manual - Page 3
Black Blue +12V Red + 12V = POWER SUPPLY Connect the BATT terminal to the positive pole of the battery with a lead cable and add a fuse into the power cable in a distance of not more than 30 cm from the battery. The lead cable's diameter should be at least 4 mm' for a length of 3 m and 6 mm" for a - Pyle PLUTV58BKA | Instruction Manual - Page 4
less prone. There is often interference caused by the generator (piping), ignition (cracking) or other vehicle/or boat electronic parts. Most of these problems can be eliminated by correct and careful cabling. In doing so, here are the following guidelines: • Use only a screened audio cable for the - Pyle PLUTV58BKA | Instruction Manual - Page 5
PLUTV58BKA Speaker Installation Speaker Mounting suggestion as below: STEP 1 STEP 2 STEP 3 STEP 4 STEP 5 Auto Reconnection: Step 1: Put the PLUTV58BKA speaker in a safe place. Step 2: Slide in the buckle with rubber pad attached to the bracket stand of the speaker. Attach the set to the handle - Pyle PLUTV58BKA | Instruction Manual - Page 6
c. Disconnected BT after 10 minutes, you need to process BT connection steps (above) to reconnect BT again. d. If the other device occupied the BT during this period (10mins), you need to process BT connection steps (above). PLAYING MUSIC 1. Press and hold for 3 seconds to Power ON or OFF. 2. Short - Pyle PLUTV58BKA | Instruction Manual - Page 7
AUX Input Fuse: 5A USB +YELLOW -BLACK Remote Out (Blue) ACC Remote In (Red) PLUTV58BKA WIRE DIAGRAM 12 www.PyleUSA.com DC12V(-) Grounded to metal chassis, or directly to negative polarity of battery. Line out-L Line out-R +12v Red DC12V(+) Recommended wiring with fuse (parts are not included) - Pyle PLUTV58BKA | Instruction Manual - Page 8
Ampli er Technical Specs: • Amplifier Type: 2-Ch. Audio Component • Power Output: 1000 Watt MAX • 2 x 50 Watts RMS @ 4 Ohm • 2 x 150 Watts MAX @ 4 Ohm • Marine Grade IP-45 Rating • T.H.Dɿ≤ 1% • S/N Ratioɿ≥ 80dB • Channel Separationɿ≥ 65dB • Fuse: 15A • Power: DC 12V • Amp Dimensions (L x W x H): 6"
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
Questions? Issues?
We are here to help!
Phone:
(1) 718-535-1800
Email:
5.25'' Waterproof Marine Speakers
+ 2 Ch. Rated Amplifier +Wireless BT Audio Controller
ATV, UTV, 4x4, Jeep, Wired RCA, for Boat Stereo Speaker
and Other Watercraft (1000W)
PLUTV58BKA