Pyle PRJ3D99TU PRJ3D99TU Manual 1 - Page 33
Using, Using the, the projector, projector
View all Pyle PRJ3D99TU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Using the projector Starting up 1.Plug the power cable into the projector and into a wall socket. Turn on the wall socket switch (where fitted) and the power switch on the projector. Check that the Power indicator on the projector lights red after power has been applied. 2.Press the POWER button on the projector or remote control to turn the projector on. The projector will be started up immediately. 3.Switch on the connected equipment. 4.Press the SOURCE button on the projector or remote control to choose the input source you want. See "Switching input signal" on Page 32 for details. Note: If the frequency/resolution of the input signal exceeds the projector's operating range, it will not operate normally. Please change to an input signal which is compatible with the projector's resolution or set the input signal to a lower setting. Switching input signal The projector can be connected to multiple equipment at the same time. However, it can only display one at a time. Press the SOURCE button repeatedly on the projector or remote control, then the input source will be changing as the following: 33