Pyle PRJELMT86 Instruction Manual

INSTALLATION AND USAGE OF ELECTRIC SCREEN:

When you need to hang projection

screen on the ceiling, you should

install two pieces of pothooks at

the corresponding position on the

ceiling first, then latch on hanging

hook which is on the end cap of

projection screen.

CEILING MOUNT:

Press the

UP

button to raise the

screen and the

DOWN

button to

lower the screen for viewing. Press

STOP

at any point to position the

screen anywhere in between its

highest and lowest position

* NOTE: Screen can be controlled by both wired and

wireless controllers

REMOTE USAGE:

WALL MOUNT:

There is a key ring on the bracket

at both ends of the screen, when

you need to hang projection

screen on the wall, you should

hammer down nails or install

screws

at

the

corresponding

position on the wall first, then

hang up the screen.

Carefully remove the screen after opening the box. Be careful

not to damage the surface of the screen or its housing during

this process.

According to projecting requirements, fix up the wall shelf

securely.

(Note that the two wall shelves must be at the same

height, otherwise screen surface will be slanted to one side)

Carefully hang the screen on the wall shelf.

Once installation is complete, a red light will show on the switch box

when the screen is powered on. Press the

UP

and

DOWN

switch on

the switch box to make sure the screen functions normally.

Use either the wired, or included wireless remote to control the

screen according to your preference.

1.

2.

3.

4.

5.

NAIL

WALL

SCREEN DIRECTION

SCREEN

HOUSING

SCREEN DIRECTION

SCREEN

HOUSING

CEILING

POTHOOK

HANGING

HOOK

SCREEN

HOUSING

WIRED

REMOTE

HANGING

HOOK

Pyle PRJELMT86 Instruction Manual

Pyle PRJELMT86 Manual

Pyle PRJELMT86 manual content summary: