Pyle PT110 PT110 Manual 1
Pyle PT110 Manual
 |
View all Pyle PT110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Pyle PT110 manual content summary:
- Pyle PT110 | PT110 Manual 1 - Page 1
High Performance Professional Audio MODEL:PT110/PT210 PA AMPLIFIER www.pyleaudio.com - Pyle PT110 | PT110 Manual 1 - Page 2
this manual throughly before you attempt to set up and use the amplifier. It contains a range of installation suggestions as well as instructions to ensure safe usage. Installed properly, you can expect years of trouble-free service from this product. FEATURES AND CONTROLS FRONT PANEL - PT110/PT210 - Pyle PT110 | PT110 Manual 1 - Page 3
sources. PHONO/AUX Allows you to select and connect an alternative high level (AUX/CD) or low level (PHONO) audio sound source. 6.Tone Control (PT110) Lets you adjust the sound frequency to the acoustics of a particular performance environment. 7.100 Hz, 1 kHz, & 8 kHz Equalizer Controls (PT210 - Pyle PT110 | PT110 Manual 1 - Page 4
to connect another PT110/PT210 to this jack to double the size of your PA system. 16.Push-Terminal Connectors Let you easily connect speaker wires directly to the amplifiers. INSTALLATION GUIDELINES Connecting the GND (GROUND) screw terminal If you connect a low level audio input source (turntable - Pyle PT110 | PT110 Manual 1 - Page 5
used for greater lengths. System 1: Single speaker system 1.Connect the speaker (-) terminal to the amplifier COMMON terminal 2.Depending on the speaker being used, connect the speaker (+) terminal to the amplifier's 4-Ohm, 8Ohm or 16-Ohm amplifier terminal. Connecting a turntable In this Situation - Pyle PT110 | PT110 Manual 1 - Page 6
1.Connect the LEFT SPEAKER (-) to the RIGHT SPEAKER (-). 2.Connect BOTH the LEFT SPEAKER (-) and the RIGHT SPEAKER (-) to the amplifier COMMON terminal. 3.Connect the LEFT SPEAKER (+) to the RIGHT SPEAKER (+). 4.Connect BOTH the LEFT SPEAKER (+) and RIGHT SPEAKER (+) to the amplifier 4-Ohm, 8-Ohm or - Pyle PT110 | PT110 Manual 1 - Page 7
speakers, and may reguire hook up to the 8 or 16 Ohms terminal. amplifier 70V RMS terminal. If you wish a particular speaker to have a higher volume level,connect the wire from 70V RMS to a higher wattage tap on the transformer. Connecting to 4A/12V DC power (PT110) You can power the amplifier - Pyle PT110 | PT110 Manual 1 - Page 8
YOUR VEHICLE'S DEALER. Turning the amplifier on 1.Turn on the audio input source equipment which is connected to the amplifier INPUT jack. 2.Set all volume amplifier, causing permanent damage. Using the MIX BUS jack You can connect another PT110/PT210 to this jack to double the size of your PA
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
MODEL:PT110/PT210
PA AMPLIFIER
High Performance Professional Audio
www.pyleaudio.com