Pyle PWPLGU204 Instruction Manual

readings prior to the installation of the wall plate to ensure

power has been disconnected.

Do not remove the outlet's wall plate until you are

certain that the outlet is not live. Exposed, live 120 volt AC

devices such as wall outlets and light switches can cause

severe injury, even death.

2.

REMOVE THE EXISTING FACE PLATE COVER

Using a flat head screwdriver, remove the existing wall

plate. The screw is located above and bottom of the wall

socket. Turn the screwdriver counter-clockwise to remove

the screw.

3.

INSTALL USB WALL PLATE CHARGER

Line up the Decor outlet hole in the USB wall plate over

the socket of the exposed outlet and press the wall plate

on to the outlet. Ensure the 2 metal contacts on the back

of the wall plate are alligned with the metal costal contacts

on the sides of the wall electrical outlet. Install the top and

the bottom screws provided with the wall plate, to attach

the wall plate to the outlet. Turn the screwdriver clockwise

to tighten the walk plate firmly against the wall.

USB Charging Power Outlet Snap-On Cover

Snap-On USB Wall Power Outlet Frame Plate

Smart USB Charging Outlet Cover with Device Holder

PWPLGU204

This USB wall plate is the easiest way

to

add USB Fast-Charging capability to 15

Amp standard decor electrical

outlets in

a home or business. For 20Amp outlets,

contact the dealer for alternate units.

Simply replace an existing single decor

wall plate with the Charger and enjoy

easy device charging

that's always

ready to go.

The wall plate connects to a 15 amp standard decor outlet

and provides 2 USB charging ports without using up either

outlet electrical socket.

Please follow these directions carefully to safely install this

product.

CAUTION

It is critical to confirm that power has been shut off from the

fuse panel or circuit breaker box to the designated outlet

before starting the replacement. Teplacement of electrical

system wall plates cannot be done safely unless power has

been disconnected at the breaker panel or fuse panel for the

property. Test the outlet, with a voltage meter capable of

making the proper readings prior to the installation of the

wall plate, to ensure power has been disconnected.

You need to prepare a flat head screwdriver for this installation.

INSTALLATION

Installing this wall plate takes just 3 simple steps:

1.

TURN OFF THE POWER

Locate the electrical cutoff point (breaker panel, fuse panel,

etc.) for the outlet to be used. Turn off the breaker switch or

remove the fuse.

Hint

- It may help to plug in a lamp or similar device to the

outlet and turn it on. When you have found the correct

breaker or fuse, the light will go out. Additionally test the

outlet with a voltage meter capable of making the proper

1

2

3

Restart power to the outlet after con±rming that the

installation is correct!

Congratulation! Your already ±nished the installation and now

just start to charge.

CLEANING

Clean the charger with a soft,dry cloth. lf a mild detergents

needed to clean tougher spots, shut off the outlet from the

fuse panel or circuit braker box and make sure that no

moisture gets inside the USB ports or outlet on the front of

the unit.

SUPPORT

If you have any questions or concerns which are not

addressed in this document, please contact

PyleUSA

tech

suupport. Do not attempt to troubleshoot any electrical

outlet without proper training.

Pyle PWPLGU204 Instruction Manual

Pyle PWPLGU204 Manual

Pyle PWPLGU204 manual content summary: