RCA AMP1450F User Guide

AMP1450F / AMP1450R / AMP1450FV

Digital Signal Amplifier For Indoor Antennas

User’s Guide

©2013 VOXX Accessories Corporation

3502 Woodview Trace, Suite 220, Indianapolis, IN 46268

www.rcaaudiovideo.com

Trademark(s) Registered

Printed in China

AMP1450_IB_03

This amplifier helps enhance the performance of all passive indoor antennas. It was engineered

specifically for digital signals. It also supports analog signals. This amplifier:

• Enhances performance of passive antennas in challenging reception situations

• Optimizes signal for the best possible reception through improved gain

• Preserves signal purity with Extremely Low-Noise (ELN) circuitry

Passive

Antenna

ANTENNA

TV/STB

TV

Installing the Amplifier

1.Make sure your TV or converter box is turned off.

2.Disconnect your antenna from your TV or converter box.

3.Connect the cable coming from your antenna to the input jack

of the amplifier.

4.Connect the amplifier’s built-in cable to the antenna input on

your TV or converter box.

5.Plug the amplifier’s power cord into an electrical outlet.

Important:

This power unit should be plugged in so that it stays vertical

or lies flat.

6.Turn on your TV or converter box and re-scan for channels.

antenna

FCC Statement:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to

operate this equipment.

Industry Canada Regulatory Information

CAN ICES-3 (B)/NMB-3 (B)

Avis d’Industrie Canada

CAN ICES-3 (B)/NMB-3 (B)