RCA L32HD32D User Guide & Warranty - Page 15

Setting the on-screen language You can choose from three different languages (English, French and Spanish) for the on-screen displays. Select the language you prefer first, then proceed with the other menu options. 1 To turn on the TV, press POWER. (POWER indicator on the front of the unit changes green. It may take approx. 10 seconds for a picture to appear on screen.) 2 Press TV/DVD to select TV mode. 3 Press SETUP/TV MENU. The TV menu screen will appear. 4 Press ▲ or ▼ to select "Setup", then press ▶ or ENTER. 5 Press ▲ or ▼ to select "Language". Setup Closed Caption >> Language English Video Label >> Backlight 16 Auto Shut Off Off Reset >> : Select : Adjust NOTE: • When you press SETUP/TV MENU first time after purchase this LCD TV, above screen will appear automatically. 6 Press ◀ or ▶ to select the desired language: English, French (Français) or Spanish (Español). 7 Press EXIT/CANCEL to return to the normal screen. NOTE: • If no buttons are pressed for more than about 60 seconds, the menu screen will return to normal operation automatically. Memorizing channels This TV is equipped with a channel memory feature which allows channels to skip up or down to the next channel set into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the TV's memory. To use this TV with an antenna, set the Signal Type option to the Air mode. When shipped from the factory, this menu option is in the Cable mode. Air/Cable selection 1 Press SETUP/TV MENU in the TV mode. The TV menu screen will appear. 2 Press ▲ or ▼ to select "Channel", then press ▶ or ENTER. 3 Press ▲ or ▼ to select "Auto Ch Memory", then press ▶ or ENTER. 4 Press ▲ or ▼ to select "Signal Type". 5 Press ◀ or ▶ to select "Air" or "Cable". Air - VHF/UHF channels Cable - CABLE TV channels Auto Ch Memory Signal Type Automatic Search Cable Start : Select : Adjust 6 Press EXIT/CANCEL to return to the normal screen. CABLE CHART The chart below is typical of many cable system channel allocations. NOTE: • It may take a few seconds for a digital channel picture to appear on screen after being selected. Automatic search 1 Press SETUP/TV MENU in the TV mode. The TV menu screen will appear. 2 Press ▲ or ▼ to select "Channel", then press ▶ or ENTER. 3 Press ▲ or ▼ to select "Auto Ch Memory", then press ▶ or ENTER. 4 Press ▲ or ▼ to select "Automatic Search", then press ▶ or ENTER. Auto Ch Memory Signal Type Automatic Search Cable Stop Analog Channel Found : 0 Digital Channel Found : 0 : Select ENTER:Cancel 5 The TV will begin memorizing all the channels available in your area. • It may take from 15 minutes to 30 minutes to complete memorizing digital cable channels. Depending on the reception condition, a bar display may not advance for several minutes, please be patient. 15 51H0101A_eng.indd 15 2/26/08 9:47:38 AM