RCA RT2380BK User Manual - Page 17

B_RT2380 EN 4/7/04 1:44 PM Page 18 Operating your Receiver You can connect up to 6 audio/video sources to this amplifier: Source button Corresponding connector (receiver front panel) (receiver back panel) - DVD - SAT - TV - VCR - CD - TAPE - FM/AM DVD IN (audio / video) SAT IN (audio / video) TV IN (audio only) VCR IN/OUT (audio / video) CD IN (audio only) TAPE IN/OUT (audio only) built-in An arrow points to the source name selected shown on the display. Example: Press DVD to select DVD as the source to the amplifier. NOTE 1. Your receiver has a built in tuner. Just connect the appropriate antenna to the back of the receiver and you will be able to listen to radio stations. (See details in Tuner section) 2. Other sources can be connected to the above standard source. Example: you can connect a LD into the DVD inputs. 3. Refer to the "Connecting To Audio-Visual Components" section for details on connection. Using the Remote to Control Additional Components You can use your remote to control most of RCA branded VCRs, satellites, cable boxes or TVs. Press the corresponding source button on the remote control to operate options on other components. NOTE The remote control can only operate RCA brand products. Volume Punchthrough NOTE Volume punchthrough can be done in all non-Tuner modes. By default, the VOL+/VOL- and MUTE buttons will only control the receiver, regardless which mode (TV, VCR, etc) the receiver is in. By programming the volume punchthrough function, you can also control the volume of the TV. NOTE Controlling the TV volume can be done in any non-Tuner modes. To activate the volume punchthrough function, follow the procedures below: 1. Press and hold the VOL- button. 2. While holding down the VOL- button, press one of the source buttons to select the source where you want to control TV volume at. (DVD, TV, VCR or SAT•CABLE) 3. Continue holding down the VOL- button and press the TV button once. 4. Release all buttons. You should now be able to control TV volume and mute at the selected device. HINT To return to controlling receiver volume and mute again, follow the steps above but press TUNER instead of TV in step 3. HINT If batteries are removed from the battery compartment of the remote control, the volume and mute control in all source modes will be the receiver volume and mute conrol except in TV mode. 14