Ricoh Aficio MP 2500 Troubleshooting - Page 91
When a Message Is Displayed, When a message is displayed on the client computer
View all Ricoh Aficio MP 2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
The Scanner Function When a Message Is Displayed This section describes likely causes of and possible solutions for error messages that may appear on the machine's display panel and the Client Computer. When a message is displayed on the client computer This section describes likely causes of and possible solutions for the main error messages displayed on the client computer when using the TWAIN driver. Important ❒ If an error message that is not included in this section appears, turn off the main power switch of the machine, and then turn it on again. For details about how to turn off the main power switch, see "Turning On the Main Power", About This Machine. Message Clear Misfeed(s) in ADF. The name is already in use. Check the registered names. Cannot detect the paper size of the original. Specify the scanning size. Cannot add any more scanning mode. Cannot specify any more scanning area. Please call your service representative. Cause Solution A paper misfeed has occurred inside the ARDF. Remove jammed originals, and place them again. After removing the misfed paper, proceed with scanning. Check whether the originals are suitable to be scanned by the machine. You tried to register a name Use another name. that is already in use. The set original was misaligned. • Place the original correctly. • Specify the scan size. • When placing an original directly on the exposure glass, the lifting/lowering action of the ARDF triggers the automatic original size detection process. Lift the ARDF by more than 30 degrees. The maximum number of reg- The maximum number of isterable scanning modes has scanning modes that can be been exceeded. stored is 99. Delete unneeded scanning modes. The maximum number of reg- The maximum number of isterable scanning areas has scanning areas that can be been exceeded. stored is 99. Delete unneeded scanning areas. An unrecoverable error has occurred in the machine. Contact your service representative. 6 83