Ricoh Aficio MP W3600 Troubleshooting - Page 37
Alert Messages, This describes the machine Alert messages.
View all Ricoh Aficio MP W3600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
When a Message Appears Alert Messages This section describes the machine Alert messages. Message Cause Solution Cannot connect with the wireless card. Turn the main power switch off, then check IEEE 802.11b interface unit was not inserted when the machine was turned on. Turn off the machine and check the interface unit is inserted correctly. Then, turn the machine on again. If the message appears again, call your service representative. the card. 3 Cannot connect with the wireless card. Turn the main power switch off, then check IEEE 802.11b interface unit was pulled out after the machine turned on. Turn off the machine and check the interface unit is inserted correctly. Then, turn the machine on again. If the message appears again, call your service representative. the card. Problems with the wireless card. A wireless card that the machine cannot use has been installed. Turn off the machine and check the interface unit is inserted correctly. Then, turn the machine on again. If the message appears again, call your service representative. Problems with the wireless board. Access to the wireless board in which the IEEE 802.11b interface unit is inserted is possible, but an error was detected. Turn off the machine and check the interface unit is inserted correctly. Then, turn the machine on again. If the message appears again, call your service representative. Problem with Hard An error has occurred in Turn off the main power switch, and back Disk. the hard disk drive. on again. If the message appears again, contact your service representative. The entered pass- The password of the en- Enter the correct password. word is incor- crypted PDF file has rect. been entered incorrectly. Error has occurred. A syntax error, etc., has Check the PDF file is not corrupted. occurred. USB has a problem. An error has occurred in Turn off the main power switch, and back the USB interface. on again. If the message appears again, contact your service representative. Hardware Problem: An error has occurred in Turn off the main power switch, and back Ethernet the Ethernet board. on again. If the message appears again, contact your service representative. Printing privileges have not been set for this document. You tried to print a print- You cannot print this document. protected document. 31