Ricoh FW780 Service Manual - Page 104

Rev. 12/22/95 Mode No. Optional Paper *23 Size Setting to *32 Function Data Up to 10 different paper size can be stored UdEF: Undefined from 23 to 32. If "19" is selected in SP No. 22, this data is used as fixed paper size when the "Preset Cut" key is pressed. 33 Not Used to 34 All Indicators On *35 New Developer Initialization 36 37 Not Used Release Fusing 38 Unit Service Call 39 Not Used Roll Feeder 40 Identification Roll Feeder 41 Speed Setting (Factory Use) Roll Feeder 42 Cutting Length Adjustment (300 mm, Plain Paper) Roll Feeder Cutting Length 43 Adjustment (300 mm, Translucent Paper) Roll Feeder Cutting Length 44 Adjustment (300 mm, translucent Film) Turns on all the indicators on the operation panel when the Roll Feed Select key is pressed. 0: No 1: All indicators on Carries out the new developer initialization for If the initialization is 5 minutes. The machine counts down the canceled before remaining time on the display. After the returning to the initialization, the machine automatically normal operating adjusts the toner sensor output to 4.0 ± 0.1V. mode, do it again During the toner sensor adjustment, "Adj" is from the beginning. If displayed. When the adjustment is the machine fails to completed, the machine automatically returns adjust the toner to normal operating mode. sensor output, "E=11" is indicated. Recovers from the fusing unit SC condition. After it has been recovered, the machine returns to its initial (power on) condition. 0: Release SC 1: SC condition Identify the roll feeder installation. To adjust the paper feed speed of the roll feeder. To adjust the cutting length of 300 mm in the plain paper mode. 0: No 1: Roll Feeder Installed 0: Standard --50 ← 0 → 50 Faster Slower 0: Standard --9.9 ← 0 → 9.9 mm Longer Shorter To adjust the cutting length of 300 mm in the translucent paper mode. To adjust the cutting length of 300 mm in the translucent film mode. A163 4-12 SM