Ricoh FW780 Service Manual - Page 213
Cut length adjustment, Current SP data #42
View all Ricoh FW780 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 213 highlights
7.5 CUT LENGTH ADJUSTMENT Rev. 5/95 The cut length adjustment should be done when the roll feeder is installed to correct cutting errors. The cut error correction data is determined in the factory without the copier installed. The cut length varies depending on the copier on which it is installed and/or paper type used. If required, adjust the cut length as follows: NOTE: The cut length should be measured 10 minutes or later after copying because the fusing unit dries the paper and reduces its length temporarily. 7.5.1 Preset Cut : Adjustment standards: 3 mm (for length shorter than 420 mm) 5 mm (for 420 to 1189 mm) NOTE: There are three settings of the cut length depending on the temperature mode. They are set in the factory to match a standard paper type. [Normal (SP#42, 45), High (SP#43, 46), Low (SP#44, 47)]. 1. Make 5 copy samples of A0 lengthwise (1189) and A3 sideways (297) in the preset cut mode. 2. Measure the difference of the length between the each copy sample and preset cut length (1189 and 297). Then, calculate the average difference. 3. Input the average value using SP modes #42 to 47 so that the cut length is within the adjustment standards. Example: 1. Current SP data #42....0 Copy sample length = 297 -- 4 Set SP mode #42...4.0 2. Current SP data #42....0 Copy sample length = 297 -- 4 Set SP mode #42...+ 4.0 4. Make A0 lengthwise and A3 sideways copies using preset cut mode and check their length. 5. Repeat steps 2 to 4 if necessary. SM 7-21 A163