Ricoh FW780 Service Manual - Page 371
Clear Modes key [A], Length, Temperature
View all Ricoh FW780 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 371 highlights
INSTALLATION PROCEDURE [A] [G] [D] Installation [E] [C] [B] [F] Length Temperature 300 NORMAL XX PRG. NO. 42 B435I508.WMF 1100 XX PRG. NO. 45 23. Plug in the power supply cord and turn on the main switch. 24. To enter the SP mode, press the following keys on the operation panel: Clear Modes key [A] + key [B] - key [C] Clear/Stop key [D] Clear/Stop key [D] again and hold it for at least 3 seconds. 25. After 3 seconds, the roll paper end and call service indicators will blink (SP mode). 26. Select 40 using the + and - keys. Enter "1" (B435: 1 roll) or "2" (B436: 2 rolls) by pressing the following keys. Function Select key [E] + key RF Select key [F]. 27. To set the paper cut length adjustments, input values into SP modes 42 and 45 as listed on the decal attached to the right side plate. NOTE: 1) When the values for SP modes 42 and 45 are set, the paper cut length adjustment values for vellum and film are automatically entered (SP modes 43, 44, 46 and 47). 2) In the case of the 2 roll feeder, you must enter values for both the 1st and 2nd roll. The value for the 1st roll can only be entered when the corresponding indicator [G] is blinking (same for 2nd roll). Use the Function Select Key to switch between the two rolls. 28. Press the Clear Modes key 3 times to leave the SP mode. 29. Check the roll feeder operation. SM 3-27 B047/B048