Ricoh FW780 Service Manual - Page 381

SERVICE TOOLS Mode No. Function Data Toner End 50 Detection Setting Determines the maximum number of copies (when A1 paper is used) that can be made after the toner near end condition has been detected. 0: 27 sheets 1: 9 sheets 2: 18 sheets 3: 36 sheets Toner Overflow Detection Setting 51 Determines the maximum copy length that can be made after the toner near overflow condition has been detected. 0: 30 m 1: 6 m 2: 53 m 3: 77 m 4: 100 m 5: 142 m Used Toner Counter 52 Indicates the maximum copy length that can be made before the used toner near overflow condition is triggered This counter is automatically cleared when the toner overflow condition is cleared after emptying the used toner tF=XX,XXX (Beeper) in the bottle. Used Toner Counter Clear 53 Manually clear the used toner counter. 0: Full toner condition is not detected 1: Full toner condition is detected. To clear the counter, input "0" even if "0" is already indicated. Developer Warm-up Setting 54 Sets the developer agitation time. If the fusing temperature is lower than 60°C when the main switch is turned on, the main motor rotates for the set amount of time, generating a triboelectric charge on the developer and toner. 0: 50 seconds 1: 2 minute 2: 3 minute 3: None Paper Length Limit Determines the maximum paper (In mm mode) Setting length. 0: 3,000 mm 1: 3,600 mm Note: 2: 5,200 mm If paper longer than 2,000 mm is used, 3: 6,800 mm you may experience skewed or 4: 8,400 mm creased copies, poor fusing, or 5: 9,999 mm 55 damage to the original. (In inch mode) 0: 118.0 inch 1: 160.0 inch 2: 240.0 inch 3: 320.0 inch 4: 400.0 inch 5: 480.0 inch Service Tables SM 4-7 B047/B048