Ricoh FW780 Service Manual - Page 392

SERVICE TOOLS Mode No. Function Data Synchro-cut Length Auto Adjustment (297 mm) Adjusts the original cut length in Synchro Cut mode based on a 297 mm sheet (standard length). Insert the -9.9 ← 0 → 9.9 1 step = 0.1 mm 297 mm length original five times (this number displayed on the copy number indicator can be changed : 1 to 10). If the actual original length is different -35 from the standard length, input the following value in the cut length indicator before inserting the original: Actual Length - Standard Length Then the machine automatically calculates the correct value, and the value of SP#-38 is changed. Synchro-cut Length Adjusts the original cut length in Auto Adjustment Synchro Cut mode at 1,189 mm. -50 ← 0 → 50 1 step = 0.1 mm (1,189 mm) Insert the 1,189 mm length original five times (this number displayed on the copy number indicator can be changed: 1 to 10). If the actual original length is different from the standard -36 length, input the following value in the cut length indicator before inserting the original: Actual Length - Standard Length Then the machine automatically calculates the correction value. The data is overwritten on SP#-39. -37 Not Used Synchro-cut Length Adjusts the synchro cut length for a Manual Adjustment 297 mm original. Increasing the -38 (297 mm) number will shorten the paper cut length. -9.9 ← 0 → 9.9 1 step = 0.1 mm (This value is over written when SP#-35 is performed.) Synchro-cut Length Adjusts the synchro cut length for a Manual Adjustment 1,189 mm original. Increasing the -39 (1,189 mm) number will shorten the paper cut length. -50.0 ← 0 → 50 1 step = 0.1 mm (This value is over written when SP#-36 is performed.) -40 Not Used to -44 Roll Feeder -45 Registration Adjusts the paper registration from the roll feederS. When SP#-5 (Registration Adjustment) is carried out, this data will be automatically set with that data. 0: Standard -9.9 ← 0 → 9.9 Delay Advance Forced Ready Condition -50 (Factory Use) Forces the machine into the "Ready" condition regardless of the fusing temperature. This mode cannot be 0: Normal 1: Forced Ready Condition used during the start-up development agitation. -51 Lamp Off Mode Fluorescent lamp does not turn on during the copy cycle. 0: Normal 1: Lamp off B047/B048 4-18 SM