Ricoh FW780 Service Manual - Page 397
INPUT/OUTPUT CHECK MODE, Program No., Sensor/Switch/Signal, Electrical Component
View all Ricoh FW780 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 397 highlights
SERVICE TOOLS 4.3.2 INPUT/OUTPUT CHECK MODE Input Check Mode Table The on/off status of the selected electrical component is displayed in the paper length indicator ("ON" or "OFF" is displayed). If the selected program number is not used, "NOT" is displayed. Program No. -1 -2 -3 -4 -5 -6 -7 -8 -9 -10 -11 -12 -13 -14 -15 -16 -17 -20 -21 -24 -26 Sensor/Switch/Signal Registration Sensor Exit Sensor Original Registration Sensor Entrance Sensor Main Motor LOC Signal (Status is "ON" when the main motor is rotating normally.) Door Switch (Status is "ON" when the door is open.) Original Entrance Sensor (B048 copier only) Original Rear Sensor (B048 copier only) Not Used R/F Leading Edge Sensor Roll Feeder Door Switch Right Cutter Switch Left Cutter Switch Paper End Sensor (1st Roll) Paper End Sensor (2nd Roll) Exit Cover Open (Status is "ON" when the door is open.) Used Toner Cover Switch Toner Overflow Sensor Toner Overflow Sensor Connection Total Counter Fusing SC Detection Service Tables Output Check Mode Table Press the " key to turn on the selected electrical component. The status of the component is displayed in the paper length indicator. To turn off the component, press the " key again. Program No. 0 1 2 3 4 5 6 7 Electrical Component Main Motor Toner Supply Clutch Pick off solenoid Registration Clutch Total Counter Pre-transfer Lamp Quenching Lamp Fusing Lamp Note SM 4-23 B047/B048