Ricoh FW780 Service Manual - Page 82
Clear/Stop key [C], Clear Mode key [A]
View all Ricoh FW780 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Rev. 5/95 [D] [B] [A] [C] [E] NOTE: If the fusing temperature is lower than 60°C when the main switch is turned on, the main motor will rotate. In this case, it is not necessary to access the SP mode when loading the second Kg of developer (in step 11). Turn off the main switch to stop the main motor after the developer is loaded from the development entrance. 8. Press the following keys on the operation panel: Clear Mode key [A] + key [B] + key Clear/Stop key [C] 9. Press the Clear/Stop key again for longer than 3 seconds. The wrench and toner end indicators will blink (SP INPUT/OUTPUT mode). 10. Select 23 using the + key [D] and press the RF Select key [E]. The main motor will rotate. 11. Press the RF Select key to stop the main motor after the developer is loaded from the development entrance. Pour in another kg of developer into the development unit evenly across its width (Total: 2 Kg). Press the Clear Modes/Stand by key 3 times to leave the SP mode. A163 3-8 SM