Rocketfish RF-G1502 Quick Setup Guide (English)
Rocketfish RF-G1502 Manual
 |
View all Rocketfish RF-G1502 manuals
Add to My Manuals
Save this manual to your list of manuals |
Rocketfish RF-G1502 manual content summary:
- Rocketfish RF-G1502 | Quick Setup Guide (English) - Page 1
QUICK SETUP GUIDE RF-TVMLPT01 Thank you for choosing the Rocketfish RF-TVMLPT01. The RF-TVMLPT01 TV mount is designed to support a TV weighing up to 50 lbs. (22.7 kg). 1 Install locking screw Install the TV bracket locking screw (G) into the TV bracket (A) using the hex key (H). Do not screw in - Rocketfish RF-G1502 | Quick Setup Guide (English) - Page 2
, contact Customer Service or call a qualified contractor. Rocketfish is not responsible for damage or injury caused by incorrect installation or use. The weight of your TV must not exceed 50 lb (22.7 kg). The wall must be capable of supporting five times the weight of the TV and wall mount combined
-
1 -
2
 |
 |
Tools you will need:
• Stud finder
• Awl
• Level
• Pencil
Package contents
A
TV bracket (1)
B
Wall plate (1)
M4 bag
C
M4 x 12 mm screws (4)
D
M4 x 30 mm screws (4)
E
M4 washers (4)
F
M4 spacers (4)
Miscellaneous bag
G
Locking screw (1)
H
5/32 in. hex key (1)
Lag bolt bag
I
5/16 in. x 2¾ in. lag bolts (2)
J
Concrete anchors (2)
Thank you for choosing the
Rocketfish RF-TVMLPT01.
The RF-TVMLPT01 TV mount
is designed to support
a TV weighing up to
50 lbs. (22.7 kg).
• Hammer (Concrete Only)
• Tape measure
• Power drill
• 3/16 in. wood drill bit
• 3/8 in. masonry
drill bit(Concrete Only)
• Socket wrench with ½ in. socket
or adjustable wrench
• Phillips screwdriver
QUICK SETUP GUIDE
RF-TVMLPT01
M4 x 12mm
in.
M4 bag
Miscellaneous bag
Lag bolt bag
A
B
C
D
G
H
I
J
1 Install locking screw
Install the TV bracket locking screw (G) into the TV bracket (A) using the hex key (H).
Do not screw in more than three or four turns.
2 Attach the TV bracket
Option 1: If the back of the TV is flat
Align the TV bracket (A) with the mounting screw holes
on the back of the TV. Place the washers (E) over
the screw holes on the TV bracket.
Note:
If the hole pattern on your TV is 75 mm x 75 mm,
do not use the washers. Insert the screws (C) though
the screw holes and tighten.
G
H
A
E
C
With washers
M4 x 30mm
E
F
M4
M4
A
C
Without washers
Option 2: If the back of the TV is curved or to make room for cables
Attach the TV bracket [A] to the back of the TV using the washers (E), the spacers (F), and the screws (D).
Note:
If the hole pattern on your TV is 75mm x 75mm the washers(E) will not be used.
A
E
F
D
A
D
F
With washers
Without washers