Ryobi ACRM006 Operation Manual

Ryobi ACRM006 Manual

Ryobi ACRM006 manual content summary:

  • Ryobi ACRM006 | Operation Manual - Page 1
    ACRM006 COMBO BLADES REPLACEMENT BLADES ACRM007 BAGGER BLADES FOR USE WITH RYOBI ELECTRIC ZERO TURN LAWN MOWER WARNING: To reduce the risk of injury, user must read and understand the operator's manual for their riding lawn mower before using this accessory. Save these instructions. Refer to them
  • Ryobi ACRM006 | Operation Manual - Page 2
     Remove the blade nut, spring washer, and blade.  Place the new blade on the shaft against the corresponding blade posts. Ensure blade is properly seated with shaft going through center blade hole and the two blade posts inserted into their respective holes on the blade. Make sure it is installed
  • Ryobi ACRM006 | Operation Manual - Page 3
    LAMES DOUBLES ACRM006 LAMES DE RECHANGE LAMES D'ENSACHAGE ACRM007 À UTILISER AVEC LA TONDEUSE É pour instruire les autres utilisateurs. Si cet produit est prêté, il doit être accompagné de ces instructions. Le jeu de lames et les lames d'ensachage sont vendus séparément. À des fins pratiques,
  • Ryobi ACRM006 | Operation Manual - Page 4
     Mettez une pièce de bois entre la lame et le châssis de la tondeuse pour empêcher la lame de tourner.  Desserrez l'écrou de la lame en le tournant dans le sens antihoraire (par rapport au bas de la tondeuse) en utilisant une clé de 15 mm ou une douille (non fournies).  Enlevez l'écrou de lame,
  • Ryobi ACRM006 | Operation Manual - Page 5
    COMBO DE CUCHILLAS ACRM006 CUCHILLAS DE REEMPLAZO CUCHILLAS DE LA EMBOLSADORA ACRM007 PARA USAR CON LA PODADORA ELÉCTRICA DE GIRO CERO RYOBI ADVERTENCIA: Para reducir el riesgo de lesiones, el usuario debe leer y comprender el manual del operador de la podadora de pasto tipo tractor antes de
  • Ryobi ACRM006 | Operation Manual - Page 6
     Introduzca a presión un bloque de madera entre la cuchilla y el piso de la podadora para evitar que la cuchilla gire.  Afloje la tuerca de la cuchilla al girarlo a la izquierda (como se observa en la base de la podadora) usando una llave de tuercas o de boca tubular de 15 mm (no se suministra).
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6

REPLACEMENT BLADES
FOR USE WITH RYOBI
ELECTRIC ZERO TURN LAWN MOWER
WARNING:
To reduce the risk of injury, user must read and under-
stand the operator’s manual for their riding lawn mower
before using this accessory. Save these instructions.
Refer to them frequently and use them to instruct other
users. If you loan someone this product, loan them these
instructions also.
Combo blades and bagging blades are sold separately. For
purposes of the illustrations in this manual, only combo
blades are shown. However, bagging blades would install
in the same way.
INSTALLING BLADES
See Figures 1 - 2.
WARNING:
Only use replacement blades and blade bolts authorized
by the manufacturer of your riding mower. Unauthorized
blades and/or blade bolts could break, allowing the blade
to come loose, resulting in possible serious personal
injury and damage to the mower.
NOTE:
Make certain all parts are replaced in the exact order
in which they were removed.
Make sure drive levers are in open position and blade
engage knob is down.
Stop the motor, remove the start key, and set the parking
brake.
Raise the height of the cutting deck to its highest position
to allow access to blades.
NOTE:
If necessary, raise the mower by placing on a lift
or using a jack and jack stands to gain access to the
blades.
WARNING:
If raising the mower to access the blades, make sure the
mower is properly secured and the parking brake is set
before proceeding. Failure to properly secure the mower
could cause it to fall, resulting in death or possible serious
personal injury.
Wedge a block of wood between the blade and mower
deck to prevent the blade from turning.
Loosen the blade nut by turning it counterclockwise (as
viewed from bottom of mower) using a 15 mm wrench
or socket (not provided).
ACRM007 BAGGER BLADES
ACRM006 COMBO BLADES
Fig. 1
BLOCK OF WOOD
BLADE
WRENCH
English
Fig. 2
BLADE
BLADE
NUT
BLADE
CIRCLE
POST
SHAFT
BLADE HALF
CIRCLE POST
SPRING
WASHER
BLADE
HALF
CIRCLE
HOLE
BLADE
CIRCLE HOLE
CENTER
BLADE
HOLE