Ryobi RY08420 Engine Starting Procedure

Ryobi RY08420 Manual

Get Ryobi RY08420 PDF manuals and user guides View all Ryobi RY08420 manuals
Add to My Manuals
Save this manual to your list of manuals

Ryobi RY08420 manual content summary:

  • Ryobi RY08420 | Engine Starting Procedure - Page 1
    injury, user must read and understand operator's manual before using this product. ENGINE STARTING PROCEDURE 2.6 oz. 1 GALLON GAS 50:1 Ratio = Mix 2.6 oz 2-cycle lubricant with 1 gallon of fresh gasoline in separate gas container. SHAKE. Pour into fuel tank. Slowly press the primer bulb 10 times
  • Ryobi RY08420 | Engine Starting Procedure - Page 2
    le volet de départ en position d'étranglement START (démarrage). Coloque la palanca del anegador en la posición START (arranque). Tirer du produit, appeler le service d'assistance téléphonique Ryobi®! ¡Si tiene preguntas conseils pour le dépannage. El manual del operador ofrece sugerencias para la
  • 1
  • 2
ENGINE STARTING PROCEDURE
990000090
9-27-12 (REV:03)
Depress the STOP switch to
the stop position “O”
.
To Stop:
For any questions about operating or maintaining your product, call the Ryobi
Help Line !
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator’s manual.
Go to
www.ryobitools.com
and register your new tool on-line.
CALL
1-800-860-4050
www.ryobitools.com
®
50:1 Ratio = Mix 2.6 oz 2-cycle lubricant with
1 gallon of fresh gasoline in separate gas
container. SHAKE. Pour into fuel tank.
1 GALLON
GAS
2.6
oz.
WARNING:
This Engine Starting Procedure is not a substitute for reading
the operator’s manual. To reduce the risk of injury, user must read and under-
stand operator’s manual before using this product.
Pull starter grip and rope sharply until engine attemps to run. Do
not pull starter grip more than 5 times.
Pull the starter grip and rope until the engine runs. Do not pull
starter grip more than 6 times.
NOTE:
If engine does not not start, return to the START
position A and repeat the steps that follow.
x10
Slowly press the primer bulb 10 times.
NOTE: After the 10th press, fuel should be visible in the primer bulb. If it is not, continue
to press the primer until you see fuel in the bulb.
Unlock the cruise control (set to Idle)
Set the choke lever to " START" position A.
Set the choke lever to the " RUN " position B.
Pull starter grip sharply until engine attemps to run. Do not pull starter grip more than 4 times.
L
ock the cruise control (set to full throttle)
Set the choke lever to the " RUN " position B.