Ryobi RY38BP Operation Manual 1

ENGINE STARTING PROCEDURE

995000444

5-10-2018 (REV:01)

Depress the STOP switch.

For any questions about operating or maintaining your product, call the Ryobi

™

Help Line!

Your Product has been fully tested prior to shipment to ensure your complete satisfaction.

Troubleshooting tips are also available in your operator’s manual.

50:1 Ratio = Mix 2.6 oz 2-cycle lubricant with

1 gallon of fresh gasoline in separate gas

container. SHAKE. Pour into fuel tank.

WARNING:

This Engine Starting Procedure is not a substitute for

reading the operator’s manual. To reduce the risk of injury, user must

read and understand operator’s manual before using this product.

Pull starter grip and rope sharply until engine attemps to run. Do

not pull starter grip more than 5 times.

Pull the starter grip and rope until the engine runs. Do not pull

starter grip more than 6 times.

NOTE:

If engine does not not start, return to the START/QUIET

position and repeat the steps that follow.

Slowly press the primer bulb 10 times.

Set the choke lever to CHOKE position. Grasp the handle

with your left hand, place your foot on the footrest.

Set the choke lever to the RUN position .

Pull starter grip sharply until engine attemps to run. Do not pull starter grip more than 4 times.

Set the cruise control lever to the START/QUIET position.

Set the choke lever to the RUN position.

NOTE:

After the 10th press, fuel should be visible in the

primer bulb. If it is not, continue to press the primer until you

see fuel in the bulb.

Set the cruise control lever to the START/QUIET position.

IDLE

START/

QUIET

FULL

IDLE

START/

QUIET

FULL

NOTICE: Do not use E15 or E85 fuel in

this product. It is a violation of federal law

and will damage the unit and void your

warranty. Only use unleaded gasoline

containing up to 10% ethanol.