Ryobi RY4CSS User Manual 2

First Time Start

First Time Assembly

Remove product from carton.

Assemble per instructions

in your operator’s manual.

1

WARNING: This Quick Start Guide is not a substitute for reading the

operator’s manual. To reduce the risk of injury, user must read and understand

operator’s manual before using this product.

2

4

Align and assemble 2 booms

until fully seated.

Snap shield into place over boom and bracket.

Secure with bolt and wing nut as shown.

3

Spread handle over boom and

snap into place. Secure with

bolt and wing nut.

- OR -

Curved Shaft

Straight Shaft

Mix 2.6 oz. 2-cycle oil with

1 gallon of fresh gasoline in

separate gas container. Shake,

then pour into trimmer tank.

5

6

8

7

Place trimmer on ground

with the trim head end facing

away from you.

Set choke lever to

FULL CHOKE position.

Repeatedly press the primer

bulb 10 times.

SQUEEZE THROTTLE

TRIGGER FULLY and pull

starter grip and rope until

engine attempts to start (no

more than 4x).

NOTE: If engine does not

start, return to step 7 and

repeat.

9

SET TO HALF CHOKE position.

11

12

SQUEEZE THROTTLE

TRIGGER FULLY and pull

starter grip until engine

runs. Allow engine to run

10 seconds, set to RUN

position.

You are now ready to Trim!

If engine did not start,

REPEAT STEPS

To stop trimmer, press

the red switch located

on the top of the

trigger housing.

Go to

www.ryobitools.com and register your new tool online.

For any questions about operating or maintaining your product,

call the Ryobi

®

Help Line!

1-800-860-4050

Your Product has been fully tested prior to shipment to

ensure your complete satisfaction. Troubleshooting tips are

also available in your operator’s manual.

For additional registration instruction, refer to operator’s manual.

10X

TRIM!

10

991000181

10-6-14 (REV:02)

7

–

11

Ryobi RY4CSS User Manual 2

Ryobi RY4CSS Manual

Ryobi RY4CSS manual content summary: