Samsung CLX 6240FX User Manual (ENGLISH) - Page 93
Installing accessories, Precautions to take when installing accessories, Upgrading a memory module,
UPC - 635753721089
View all Samsung CLX 6240FX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
installing accessories Your machine is a full-featured model that has been optimized to meet most of your printing needs. Recognizing that each user may have different requirements, however, Samsung makes several accessories available to enhance your machine's capabilities. This chapter includes: • Precautions to take when installing accessories • Upgrading a memory module • Using a wireless network interface card • Using the hard disk PRECAUTIONS TO TAKE WHEN INSTALLING ACCESSORIES • Disconnect the power cord Never remove the control board cover while the power is turned on. To avoid the possibility of an electrical shock, always disconnect the power cord when installing or removing ANY internal or external accessories. • Discharge static electricity The control board and internal accessories (network interface card or memory module) are sensitive to static electricity. Before installing or removing any internal accessories, discharge static electricity from your body by touching something metal, such as the metal back plate on any device plugged into a grounded power source. If you walk around before finishing the installation, repeat this procedure to discharge any static electricity again. When installing accessories, battery inside the machine is a service component. Do not change it by yourself. Risk of explosion if battery is replaced by an incorrect type. Dispose used batteries according to the instructions. 2. Release the screws and remove the rear cover. 3. Release the screws, then lift up the cover slightly and pull the cover to the right. UPGRADING A MEMORY MODULE Your machine has a dual in-line memory module (DIMM). Use this memory module slot to install additional memory. The machine has two memory slots with a factory pre-installed memory module in one slot. When you are expanding the memory capacity, you can add a memory module to the vacant memory slot. It is strongly recommended that you expand a memory module in vacant memory slot only without removing a pre-installed memory module. If your machine has 128 MB memory capacity and you want to add 512 MB, the memory capacity expands up to 640 MB. Order information is provided for optional memory module. (See page 91) Installing a memory module 1. Turn the machine off and unplug all cables from the machine. 1 Control board cover If you want to remove an existing memory module, push the two latches at the ends of the module outward. 4. Take out a new memory module from the plastic bag. Installing accessories_ 93