Samsung RF26VABWP/XAA User Manual (user Manual) (ver.0.4) (English) - Page 9

SETTING UP THE REFRIGERATOR Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational. 1. Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the Refrigerator. Refer to installation instructions in this manual. 2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors. 3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly. 4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the Refrigerator after the temperature is sufficiently cool. Check the accessory list below. 01 SETTING UP Water filter (DA29-00002B) Hex wrench (DA80-00002C) Fastener Compressin fitting Compression nut Clip fitting lock(red) (DA60-00143B) (DA62-00305A) (DA74-00070B) (DA61-04522A) Removing the refrigerator doors If the Refrigerator is too large to pass through your doorway easily, you can remove the refrigerator doors. Tools you will need Philips screwdriver 10mm Socket Wrench Allen wrench(3/16") Flat-blade screwdriver Pliers Disassemble the Refrigerator doors 1. W ith the door opened, remove the Top Table cap ( 1 ) with a Flat head screwdriver, and close the door. R emove the 3 screws holding down the Top Table 2 and remove the Top Table( 2 ). 1 Setting Up _9