Samsung RF4267HABP Quick Guide (easy Manual) (ver.0.1) (English)

2. Automatic Ice Maker does

not work

1. Water Line Air Purging

•

Allow your refrigerator to operate and cool

down for 24 hours (1 full day) before the ice

maker starts producing ice.

•

To fill the ice bucket to maximum capacity,

dispense a few cubes 8 and 16 hours after

installation.

•

If

ICE OFF

is lit, the ice maker will not make

ice.

•

To activate the ice maker, press the

ICE

OFF

button on the control panel so it is no

longer lit.

•

Depending on the models, the Ice Off lamps

may vary. For details, refer to the “Using the

Control Panel” section of the User Manual.

•

Refer to Water Line Air Purging for more

information.

•

When there is trapped air in the water line,

it may affect ice making and cause water

dripping. So, after installation or when

replacing the water filter, dispense at least

a gallon (2~3 minutes) of water to remove

trapped air from the water line.

12

3

6

9

•

Recommended Temp Settings

: -2°F(-19°C) for freezer and 38°F(3°C) for refrigerator.

•

Filter indicator : The filter Indicator will be Red when

you have used your water filter for 6 months, Reset the

indicator (it will be Blue) after replacing the filter by holding

the

"Alarm/Hold 3 sec for Filter Reset"

button for 3

seconds.

•

Ice off : Press the

"Ice Off"

button to turn the ice making

function off.

11. Display

•

When installing, servicing or cleaning behind the

refrigerator, be sure of the following:

•

To protect your floor's finish when moving the refrigerator,

cut a large section of the cardboard carton and place

under the refrigerator where you are working.

•

Pull the unit straight out and push back in straight after

finishing.

14. Moving and Installing

PUSH

•

Check if the ice bucket is completely

inserted.

•

Freezer temp may not be enough; set it

to -2°F(-19°C) or lower.

3. Slow Ice cube freezing

•

If the water filter is clogged, small or bubbled ice cubes

may be produced.

•

Replace the water filter cartridge with a new one.

4. Small or bubbled ice cubes or

Slow water dispensing

•

Slowly turn the water filter 90° clockwise

so it is aligned with the printing mark on

the cover, locking the filter in position.

Make sure to align the water filter label

mark with center of cover filter printing as

illustrated.

•

Refer to Water Line Air Purging for more

information.

•

The water filter may differ depending

on models. For details, refer to the user

manual

5. Water filter replacement

•

The water cooling speed may not keep up with the water

consumption. So, if the dispensed water is warm, take the

advantage of ice cubes.

6. Water is not cool enough

•

Allow your refrigerator to operate and cool down for 24

hours (1 full day) to reach to the set temperature.

•

Also, when you put room temperature or warmer food into

your refrigerator, it may need an additional 24 hours for the

fridge to reach the set temperature.

8. Refrigerator or freezer

Compartments are warm

•

If food with too much moisture is stored near the cooling

vents, it may get frozen. Be sure to keep moist food away

from the cooling vents.

13. Food stored in refrigerator is

frozen

•

Wipe off the condensation with a dry towel (This may

occur during hot and humid seasons.)

•

If the condensation occurs on the doors, turn off the

Energy Saving function.

•

If you open the doors frequently or for too long, it may

cause moisture inside the fridge.

9. Moisture forms on outside/

inside of refrigerator

•

These noises may be heard occasionally inside the

refrigerator. This is normal. This sound occurs when

various items contract or expand while temperatures are

changing; especially during defrosting. This may also

occur when electronic devices including the ice maker

are operating.

10. Noise Clicks, Pops, Cracks,

Snaps

•

You can select your Pantry temperature from among the

following.

Fresh (38°F[3°C])

Chilled (34°F[0°C])

Deli (41°F[5°C]) modes.

12. Cool Select Pantry

(on some models)

•

Insert a flat-blade screwdriver into a slot on the control

lever, turn it clockwise or counter-clockwise to level the

door.

Control Lever

Screwdriver

•

Open the freezer/flex zone door to gain an access to the

adjustable hinge pin. Next, adjust the refrigerator door

using the provided 0.16 inch wrench.

RAISE

•

If you need to add more height to the door, insert the

provided snap rings.

15. Leveling & Door Alignment

•

Until the temperature of the unit is stabilized, the water

container inside fridge keeps contracting little by little

which causes water dripping.

So, allow one or two days until the water container gets

stabilized.

•

If the water line is not inserted into the coupler properly, air

could penetrate into the water line causing water dripping

from the water dispenser.

•

CAUTION :

Insert the water line into the coupler

completely and slide in the clip at the end of the coupler.

7. Water dispenser dripping

Red Clip

(1/4")

Dispenser

Door Tube

Cabinet

Tube

The display may differ depending on models.

For details, refer to the user manual

“Using the control

panel”

DA99-01900D REV(0.1)

PUSH

<Sample>

Before calling service

If you have further questions or damaged accessory parts, contact us at 1-800-SAMSUNG (726-7864)

ENGLISH

<Sample>

Samsung RF4267HABP Quick Guide (easy Manual) (ver.0.1) (English)

Samsung RF4267HABP Manual

Samsung RF4267HABP manual content summary: