Samsung SCX 4826FN User Manual (ENGLISH) - Page 37

CHANGING THE DEFAULT COPY SETTINGS The copy options, including darkness, original type, copy size, and number of copies, can be set to those most frequently used. When you copy a document, the default settings are used unless they have been changed by using the corresponding buttons on the control panel. 1. Press Copy. 2. Press Menu until Copy Setup appears on the bottom line of the display and press OK. 3. Press OK when Change Default appears. 4. Press the left/right arrow until the setup option you want appears and press OK. 5. Press the left/right arrow until the setting you want appears and press OK. 6. Repeat steps 4 through 5, as needed. 7. Press Stop/Clear to return to ready mode. While you are setting copy options, pressing Stop/Clear cancels the changed settings and restores the defaults. ID CARD COPYING Your machine can print 2-sided originals on one sheet of A4-, Letter-, Legal, Folio-, Oficio-, Executive-, B5-, A5-, or A6-sized paper. When you copy using this feature, the machine prints one side of the original on the upper half of the paper and the other side on the lower half without reducing the size of the original. This feature is helpful for copying a small-sized item, such as a name card. This copy feature is available only when you place originals on the scanner glass. Unload the paper in ADF. 1. Press ID Copy. 2. Place the front side of an original facing down on the scanner glass where arrows indicate as shown, and close the scanner lid. 3. Place Front Side and Press[Start] appears on the display. 4. Press Start. Your machine begins scanning the front side and shows Place Back Side and Press[Start] 5. Turn the original over and place it on the scanner glass, where arrows indicate as shown. Then, close the scanner lid. If you press Stop/Clear or if no buttons are pressed for approximately 30 seconds, the machine cancels the copy job and returns to ready mode. 6. Press Start to begin copying. If the original is larger than the printable area, some portions may not be printed. If you press Stop/Clear or if no buttons are pressed for approximately 30 seconds, the machine cancels the copy job and returns to ready mode. USING SPECIAL COPY FEATURES You can use the following copy features: Collation You can set the machine to sort the copy job. For example, if you make 2 copies of a 3 page original, one complete 3 page document will print followed by a second complete document. 1. Press Copy. 2. Load originals face up into the ADF, or place a single original face down on the scanner glass. For details about loading an original, see page 29. 3. Enter the number of copies using the number keypad. 1 2 3 4. Press Menu until Copy Setup appears on the bottom line of the display and press OK. 5. Press OK when Change Default appears. 6. Press the left/right arrow until Copy Collation appears and press OK. 7. Press the left/right arrow to select On. 8. Press Start to begin copying. One complete document will print followed by the second complete document. Copying_ 37