Samsung WF210ANW/XAA (English) - Page 16
Step 3 - nf error
View all Samsung WF210ANW/XAA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
setting up your washer STEP 3 Installing your Washer 1. Place the drain hose in the drain facility (tub, sink, or standpipe.) If you connect the drain hose to a standpipe, be sure an airtight connection is NOT made between the drain hose and the standpipe. The standpipe must be at least 18 inches or 46 cm high and no higher than 96 inches. Caution must always be exercised to avoid collapsing or damaging the drain hose. For best results, the drain hose should not be restricted in any way - by elbows, couplings, or excessive lengths. For situations where the drain hose 96" Max cannot be conveniently elevated to at 18" Min least 18 in or 46 cm, the drain hose must be supported. Laundry tub Stand pipe Hose retainer Tie strap 96" Max 18" Min 2. Before connect the inlet hoses to water faucets, check to ensure a washer is inside each coupling on both ends. Coupling 3. Check the inlet hose to ensure a washer is inside each fill Cold Hot hose coupling. Thread the inlet hoses to the HOT and COLD faucet connections on the washer. On the other end of the hose, check for one rubber washer per hose and attach each fill hose to the water valve. Make sure the hose with the Hot printed line is attached to the HOT faucet. Tighten by hand until snug, then two-thirds of a turn with pliers. For correct water use, connect both HOT and COLD water valves. If either or both are not connected, an "nF" (no fill) error can occur. Rubber Washer 16_ setting up your washer WF210AN-02832A_EN.indd 16 2010-02-09 ø¿»ƒ 1:15:00