Samsung WF363BTBEUF/A1 User Manual Ver.1.0 (English, French, Spanish) - Page 17

01 SETTING UP YOUR WASHER STEP 3 Installing your washer 1. Place the drain hose in the drain facility (tub, sink, or standpipe.) If you connect the drain hose to a standpipe, be sure an airtight connection is NOT made between the drain hose and the standpipe. The standpipe must be at least 18 inches or 46 cm high and no higher than 96 inches. You must always exercise caution to avoid collapsing or damaging the drain hose. For best results, the drain hose should not be restricted in any way - by elbows, couplings, or excessive length. For situations where the drain hose cannot be 96" Max conveniently elevated to at least 18 in or 18" Min 46 cm, the drain hose must be supported. Do not insert the drain hose too far into the stand pipe: 6 - 8 inches, and no more. Laundry tub 2. Before connecting the inlet hoses to the water faucets, make sure a washer is inside each coupling on both ends. Stand pipe Hose retainer Tie strap 96" Max 18" Min Coupling 3. Thread the inlet hoses onto the HOT and COLD faucet Cold Hot connections on the washer. Attach the other end of each fill hose to a water valve. Make sure the hose with Hot printed on it is attached to the HOT faucet. Tighten by hand until snug, then tighten two-thirds of a turn with pliers. For correct water use, connect both HOT and COLD water valves. If either or both are not connected, an "nF" (no fill) error can occur. Rubber washer WF361_363_365-02832J-03_EN_20120829.indd Sec5:17 setting up your washer _17 2012-08-31 12:38:17