Sanyo DP32670 Owners Manual - Page 18

When the TV receives a digital signal, the digital information will appear. 62-1 HDTV Moving Picture1 CH-1 TV-MA Digital Air No Program Information is available Sleep Timer Off English Full 1080i • Channel number • Station name • Channel label (if preset) • Broadcast program name • V-Chip rating • Signal type • Sleep timer • Audio language • Program guide • Picture size • Resolution When the TV receives an analog signal, the analog information will appear. 14 X Analog Cable Sleep Timer Off Mono Full 480i • Channel number • V-Chip rating • Sleep timer • Audio information (Stereo, SAP or Mono) • Channel label (if preset) • Signal type • Picture size • Resolution • Broadcast program name Press DISPLAY again to clear the call display. Quick guide for menu operation Call menu and for example: Select Language. 1 Press INPUT SELECT to select TV mode. 2 Press SETUP/TV MENU. The TV menu screen will appear. Main Menu Picture >> Audio Channel Lock Setup : Select ENTER:Set 3 Press ▲ or ▼ to select "Setup", then press ▶ or ENTER. 4 Press ▲ or ▼ to select "Language", then press ◀/▶ to select the desired language. ...on the following pages the menu can be called in the same way as here. 5 Press EXIT to return to the normal screen. NOTE: • If no buttons are pressed for more than about 60 seconds, the menu screen will return to normal operation automatically. NOTE: • After a few seconds, DISPLAY screen will return to normal TV-operation automatically. RECALL This button allows you to go back to the last channel selected by pressing RECALL. Press RECALL again to return to the last channel you were watching. MUTE Press MUTE to switch off the sound. The TV's sound will be silenced and "Mute" will appear on the screen. The sound can be switched back on by pressing this button again or the VOL + or -. SLEEP To set the TV to turn off after a preset amount of time, press SLEEP on the remote control. The clock will count up 10 minutes for each press of the SLEEP button (Off, 0h 10m, 0h 20m, ..., 2h 0m). After the sleep time is programmed, the display will appear briefly every ten minutes to remind you that the sleep timer is operating. To confirm the sleep timer setting, press SLEEP and the remaining time will be displayed for a few seconds. To cancel the sleep timer, press SLEEP repeatedly until the display turns to Off. 18 54H0521A_eng.indd 18 3/17/10 4:27:55 PM