Sanyo DP42740 Owners Manual - Page 5
Getting Started - plasma tv
UPC - 086483078262
View all Sanyo DP42740 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
STAND BASE ASSEMBLY NOTE: Do not assemble the stand base if you are wall mounting the HDTV. Tools Needed: Phillips screwdriver No. 3 IMPORTANT NOTE: Place HDTV face down on a padded or cushioned surface that is larger than the screen size to protect the screen and finish. Handling by more than two people is recommended. 1 Carefully insert the stand base to the bottom of the HDTV as shown. 2 Secure the stand base with the two (2) screws supplied in the literature package. GETTING STARTED BATTERY INSTALLATION Install two (2) "AAA" batteries in the remote control. (Not included) To ensure safe operation, please observe the following precautions: • Replace both batteries at the same time. Do not use a new battery with a used battery. • There's a risk of explosion if a battery is replaced by an incorrect type. • Do not expose the Remote Control unit to moisture or heat. • Be sure to match the "+" and "-" signs on the batteries with marks inside the remote control. WALL MOUNTING CAUTION: Wall mounting of the HDTV must be performed by a skilled person. Use the screws that are threaded into the four (4) inserts on the back of your Plasma HDTV to secure it to a wall mounting kit (not included.) UNIVERSAL standard interface: 400 x 280 Mounting screws measurements: M6 Diameter, Length-12mm (max.) ANTENNA CONNECTION FOR OFF-AIR SIGNALS OR CABLE Hook up your antenna or your cable service to the HDTV's ANT terminal with the use of a 75 OHM coaxial cable. NOTE: Keep your indoor antenna at least 3 ft. away from the television set and any other electronic equipment. ANTENNA CABLE ANALOG / DIGITAL ANTENNA IN HDTV BACK The tuner in this HDTV can receive: • Digital and Analog off air signals from an antenna • Analog or ClearQAM cable channels from a direct Cable TV connection. Need help? www.sanyoctv.com 1-800-877-5032 5